Every safety recall published by the Australian government, searchable and filterable.
The surface finish on the brake hose clips may have been damaged during installation.
The front wishbone bolts may not be to the correct specification and may break.
Airbag deployments in right hand drive Model X vehicles are commanded by the vehicle’s restraint control module (RCM), which requires a valid occupant classification value to deplo…
Water may enter between the hood and windshield and cause the front wiper link ball joint to corrode, possibly resulting in the wiper link separating and the wipers becoming inoper…
Machining errors during the engine manufacturing process may cause premature bearing wear within the engine.
The screw joint holding the spring leaf attached to the spring anchorage might become loose, broken or lost during driving.
Machining errors during the engine manufacturing process may cause premature bearing wear within the engine.
There is a possibility of debris contamination during the assembly of engine units.
The seat belt pre-tensioner, on the right hand side in the third row passenger seat may have been produced with an incorrect production parameter. The seat belt will operate as int…
The fuel return hose may leak.
The fuel return hose may leak.
The cab power and ground cable terminals (eyelets) may crack and eventually fail where the terminal attaches to the cab pass through plate.
The left window airbag may not have been manufactured to specifications. In the event of an accident where the left window airbag is activated it may not deploy.
In certain Isuzu NQR series vehicles, the bolts associated with the rear left side wheel bearing nut (the rear wheel bearing hub locking bolts) may not have been properly torqued d…
The Electronic Stability Program (ESP) software does not correspond to specifications. In rare cases this may cause the brakes to remain slightly engaged after an automatic brake i…
An insufficient anti corrosion coating was applied to the end cap on the outer tube of the tailgate gas springs, which may cause corrosion.
Due to improper engine software, EV software and spark plug specification, the petrol engine may shut down unexpectedly. This will limit the vehicle to EV drive mode only, with no…
An insufficient anti corrosion coating was applied to the end cap on the outer tube of the tailgate gas springs, which may cause corrosion.
The oil line clamp used on the oil cooling system on certain MY 2017 Touring model motorcycles may not have been installed properly.
On affected vehicles manufactured with a specific period, foreign particles in the coolant may lead to a blockage in the additional coolant pump and cause the pump to overheat.
The short rubber hose section of the intercooler pipe may not be in conformance and could break during the normal use of the vehicle.
Potential occasional stalling in the engines of TR 650 Terra and TR 650 Strada model vehicles.
Electric parking brakes on some Model S and Model X vehicles built between February and October 2016 may contain a faulty gear that can prevent the parking brake from releasing. Th…
During production of the dashboard panel the process of milling the “weak points or deployment points” in the passenger side of the panel has not been carried out.These points are…
Vehicles repaired or serviced between 3 December and 5 December 2016 may have had incorrect software uploaded. The upload may affect various control units and affect numerous syste…