Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue, some of the cell modules installed in the high voltage battery may overheat at high charge levels. If this occurs, it could lead to a vehicle fire.Not…
Due to a software issue with the high-voltage battery Electronic Control Unit, the electric drive system may shut down. This could lead to a loss of motive power resulting in “EV S…
Due to a software issue with the high-voltage battery Electronic Control Unit, the electric drive system may shut down. This could lead to a loss of motive power resulting in “EV S…
Due to a manufacturing defect, the hydraulic jack in the brush chipper may extend without input from the operator. If this occurs while the vehicle is being towed, it could result…
Due to a manufacturing defect, the brake pipe may chafe against the engine and become damaged. This could lead to a brake fluid leak resulting in reduced braking performance.
Due to a manufacturing defect, the Front Underrun Protection System (FUPS) fitted to affected vehicles may have ground clearance that exceeds the compliance standard.
Due to a software issue, the Instrument Panel Cluster (IPC) may fail to illuminate the visual vehicle speed, fuel level and other critical safety information.
Due to a manufacturing defect, the shaft in the three-way valve may break and lead to a coolant leak. This may cause the valve connector to overheat and result in loss of motive po…
Due to a manufacturing defect, the low-pressure fuel pump may not operate as intended and could result in the check engine and master warning indicators to illuminate on the combin…
Due to a manufacturing defect, the lock stops on the 24V battery tray frame are missing. As a result, the tray may detach and fall when pulled out during maintenance work.
Due to a manufacturing defect, the rear centre seat belt anchor buckle may not meet specifications. As a result, the seat belt may not properly latch or operate as intended.
On certain UD Trucks, the rear axle lock washer may dislodge and chafe against the hub cover. If this occurs, it could generate metal powder, causing bearing seizure, abnormal nois…
Due to improper assembly, the internal wiring harness of the third-row left seat belt buckles may become damaged. As a result, it could prevent the vehicle from detecting whether t…
Due to a manufacturing defect, the Advanced Connected Energy (ACE) chip within the starter battery may corrode. This may cause an electrical short circuit while the vehicle is in o…
Due to a software error, the instrument cluster may fail to illuminate the visual engine oil pressure light, engine coolant temperature, electrical charge, and other critical safet…
Due to a software error, the instrument cluster may fail to illuminate the visual engine oil pressure light, engine coolant temperature, electrical charge, and other critical safet…
Due to a manufacturing defect, the low-pressure fuel feed tube may have insufficient clearance to the battery sensor wiring which could cause the fuel feed tube to become damaged.…
Due to a software issue, under certain driving conditions the electric power steering system may become temporarily inoperable. Should this occur, steering will remain functional.…
Due to a software issue, the Forward Collision Avoidance (FCA) system may continue to apply sudden/unexpected braking even though it is no longer necessary to avoid a collision or…
Due to improper assembly, the front brake line may have been incorrectly routed. As a result, it may cause restriction of the handlebar and/or excessive noise when turning. This co…
Due to a manufacturing defect, the low-pressure fuel delivery line may not meet specifications. As a result, it may deteriorate allowing fuel to potentially leak resulting in loss…
Due to a manufacturing defect, the driver and/or front passenger seat belt pre-tensioners may not operate as intended resulting in increased seat belt slack and reduced occupant re…
Due to a software issue, the electric power steering system under certain driving conditions may become temporarily inoperable. Should this occur, steering will remain functional.…
Due to a manufacturing defect, resettable circuit breakers may not have been fitted to the affected vehicles. As a result, the turn signals and external lamps may not operate as in…
Due to a manufacturing defect, some upper arm shaft on the front suspension arm may break. This may cause the tire to tilt and result in a loss of vehicle control.