Every safety recall published by the Australian government, searchable and filterable.
The roof lifting system could drop up to 450mm during opening or closing operations.
There is a potential for interference of the wiring under the dashboard within the steering column, which may cause the wiring to wear out over time.
On some units, the circlips securing the passenger footrest pivot pins may be brittle due to a manufacturing defect.
In some vehicles, the brake booster piping connector may be non-compliant with relevant standards.
There is a potential that the end connector of the diesel re-circulation pipe on the injectors may be cracked resulting in diesel seepage.
There is a potential deviation in the buckle heat treatment process. The seat belt anchorage links may not comply with safety standards.
On affected vehicles, it is possible that the side airbag gas generator housing may eject metal parts if one of the airbags is deployed.
The transmission cooler hose was not manufactured to the correct specifications. During prolonged use there is a risk of fluid leakage, which could result in mechanical failure of…
The SRS deployment software could inadvertently deploy the front airbags when it is not necessary. There is a risk of airbag deployment when the vehicle is traveling at low speed o…
The lower nut and bolt that secures the front suspension strut to the steering knuckle may not have been tightened with sufficient torque. This may cause the nut to loosen and fall…
The motorcycles may have been installed with faulty fuel tank sub harnesses.
Some brake actuators may have been assembled with a pump containing an O-ring that is damaged and as a result may not operate as intended.
The under bonnet low pressure fuel feed hose may detach from the fuel filter, causing fuel to leak into the engine bay and the engine to stall. This will also cause loss of power,…
Due to a manufacturing fault the side airbags may deploy abnormally during an accident.
The accelerator pedal could become entrapped by the floor mat in any operating position.
Due to a manufacturing fault the side airbags may deploy abnormally during an accident.
The specified limits of the roll back function of the sunroof may be exceeded when closing using the remote key.
There is a possibility that during the manufacturing process of the vehicle the adhesive used to secure the steering pinion gear to the steering gear assembly had insufficient stre…
The automatic transmission fluid cooler hose may have been improperly cured during the manufacturing process, thereby increasing the possibility of transmission fluid leaking from…
A circlip on the bearing bracket of the brake pedal may become detached from its locking position. As a result, the bearing pin can move out of one of the two bearings, impairing b…
The specified limits of the roll back function of the sunroof may be exceeded when closing using the remote key.
The fitted flange head bolts may loosen in use.
A circlip on the bearing bracket of the brake pedal may become detached from its locking position. As a result, the bearing pin can move out of one of the two bearings, impairing b…
Due to the possibility of corrosion on internal components, the restraint system control unit may fail. As a result the restraint system components such as the airbags could be dea…
Due to a deviation in the processes of the supplier, there is a risk that backrests have been supplied with lower durability.