Every safety recall published by the Australian government, searchable and filterable.
The ignition switch may become damaged internally due to engine induced vibration.
An electrical wiring harness connector may not have been completely secured to the steering column during vehicle manufacture.
There is a risk of the passenger airbag mounting screws being absent.
Risk of rear bench seat backrest mounting bolts breaking.
In the event of airbag deployment during an accident the fabric of the side airbag may tear.
The weld nuts for the child restraint anchor fitting may be missing at both the driver's and passenger side rear restraint point. There should be 3 usable points. This violates Aus…
A condition has been identified whereby, over an extended period of time, fretting corrosion may develop in a wiring connector at the Engine Control Module (ECM).
The brake pedal pivot nut on these vehicles may become loose, causing the brake pedal to be loose or inoperative.
The front suspension track bar frame bracket may have been improperly welded to the frame rail during the manufacturing process.
The driver's seat belt pre-tensioner may not operate when required.
The Occupant Restraint Control (ORC) module software on the above vehicles may contain side impact calibrations that are overly sensitive.
The steering wheel wire harness may become chafed by the driver airbag module retainer spring ends.
The diesel fuel heater electrical connector may overheat and cause a fuel leak.
Vehicles were manufactured with front axles that do not meet overall width requirements set out by Australian design Rules.
The left front brake caliper may have been cast from an incorrect material.
There may be an oil leak at the plug connection, and software for the semi active shock requires updating.
Due to an error in the manufacturing process of the supplier, small metallic particles (stamping residue) can stick to the inside of the airbag control unit housing.
In the event of a failure of the main battery the electronic ignition lock will not be supplied with power by the backup battery. If the engine stops during use the electric parkin…
The paint coating applied during the supplier's manufacturing process of the Back Door Gas Stay does not comply with the design requirement for anti-corrosion. In extremely rare ci…
1. The nut on the kick-start mechanism may come loose.2. During assembly there may have been a loose nut left inside the air box.3. Fuel hose connector on the fuel pump may have be…
The vehicle is affected by non-conforming front brake discs whose mechanical characteristics are non-compliant. This may cause a risk of reduction in the braking efficiency and cou…
There is a possibility that the sealing performance of the fuel pressure sensor to the delivery pipe could degrade over time due to improper tightening the fuel pressure sensor.
On vehicles with a 2.0l petrol engine, of a limited production period, the drive cam for the vacuum pump can break. As a result there is no vacuum assistance when applying the vehi…
Magyar Suzuki Corporation has identified a possibility that during production the front seat back may have been assembled with incorrect stitch seam spacing, outside of the manufac…
Magyar Suzuki Corporation has identified a possibility that during production the front seat back may have been assembled with incorrect stitch seam spacing, outside of the manufac…