Every safety recall published by the Australian government, searchable and filterable.
Curtain shield air bag inflators located in the driver and passenger side roof rails are composed of two chambers welded together. Some inflators could have a small crack in the we…
It is a mandatory requirement that a motorcycle must have each mechanical component accurately stamped and displayed for identification purposes according to regulation for ADR com…
The ADR83 stationary noise test information sticker is not displayed on themotorcycle.
The ADR83 Stationary noise test information sticker is not displayed on themotorcycle.
The ADR83 Stationary noise test information sticker is not displayed on themotorcycle.
Moisture may enter the air bag module because of a misalignment of the air conditioning system drain tube.
Drivers may inadvertently fail to engage the “PARK” position before exiting the vehicle.If the engine is left running, the “PARK” position is not engaged and the “PARK BRAKE” is no…
Due to a potential fault in the clutch assembly, one of the clutch components may break, increasing the risk of rear wheel lock up during use of the bike.
It is possible that the rear wheel rim might have been installed in the wrong way, with the 4 rear wheel shaft driving pins inserted in the slots rather than in the 4 relevant hole…
Low battery at engine startup combined with parking while the wheels are turned, can cause a miscalculation in the steering ratio, which may lead to a lack of steering responsivene…
The cap nut that retains the inter-axle driveshaft yoke to the rear axle input shaft may be subject to premature loosening.
The screws of the rear toe-in adjustment rods may loosen.
The door locks could have a manufacture flaw potentially causing the internal mechanism of one or more locks to jam, which could prevent one or more vehicle door(s) from closing, o…
In certain vehicles, under bonnet fuel hoses have been misrouted. The metal hose clip fitted to the under bonnet fuel hoses, in the mis-routed condition, can chafe a nylon fuel pip…
The door locks could have a manufacture flaw potentially causing the internal mechanism of one or more locks to jam, which could prevent one or more vehicle door(s) from closing, o…
A bolt retaining the accessory drive belt idler pulley may fail, leading to a loss of accessory drive. As a result, the driver may experience battery charge warning lamp illuminati…
Incorrectly sized nuts may have been fitted to the tie rods on the rear axle. If these nuts come loose it may alter the steering characteristics of the vehicle.
Due to potentially incorrect installation of some of the stop lamp switches at the point of assembly, the stop lamp switch on some of the affected vehicles may malfunction over tim…
The inner diameter of the cylinder that wraps the piston on the parking brake may be wider and therefore not sealing inside the caliper.
In the event of an accident the front left side airbag may not deploy correctly because of an incorrectly folded airbag.
The main cabin power supply cable connections may not have been tensioned correctly during production.
The inner diameter of the cylinder that wraps the piston on the parking brake may be wider and therefore not sealing inside the caliper.
Quality deviations in the production process of the connecting rod may result in early failure and fracturing of the conrod under certain load conditions.This issue is identified t…
Quality deviations in the production process of the connecting rod may result in early failure and fracturing of the conrod under certain load conditions.This issue is identified t…
The high pressure brake booster hose may come in contact with the sub frame near the left hand engine mount.