Braaap ST-250
- Affected
- 85
- Category
- Motor Bikes
- Campaign
- ST250WO0022016
- Supplier
- braaap Wholesale
The defect
It is a mandatory requirement that a motorcycle must have each mechanical component accurately stamped and displayed for identification purposes according to regulation for ADR compliance.The following parts have been incorrectly stamped for identification purposes;• Fuel Tap• Rear Master Cylinder Cap• Tail light assembly• The ADR83 stationary noise test information sticker is not displayed
The hazard
The consumer is unable to verify the authenticity and manufacturing standards of these components and there is the possibility this could lead to the incorrectreplacement of parts which may affect vehicle performance and compromise the safety of the rider.
The remedy
Customers should immediately contact and visit their place of purchase to have these components replaced at no expense.
What to do
- 1Check if your vehicle is affected. This recall covers 85 vehicles. Use your VIN to confirm.
- 2Contact braaap Wholesale to arrange inspection and repair.
- 3Repairs are free of charge when arranged through an authorised dealer.
- 4Verify this recall on the official government register: vehiclerecalls.gov.au ↗
- Website:
- http://www.braaapmotorcycles.com
Related recalls
Recall data sourced from vehiclerecalls.gov.au under CC BY 4.0.