Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing defect, the vehicle's rear driveshaft may fracture resulting in a sudden reduction of motive power.
Due to a manufacturing issue, the steering column shaft could separate from the U-joint. This may result in a loss of steering control.
Due to a manufacturing defect, the differential gear splines inside the Power Transfer Unit may wear out. This could result in a loss of motive power while driving and a loss of th…
The sealing of the firewall panel between the engine and the passenger compartments may reduce over time, allowing moisture to enter potentially causing corrosion in the electrical…
Due to a manufacturing issue, the rear seat back frames were manufactured with thicker ISOFIX wire which may exceed the Australian Design Rule 34 (ADR 34) requirement.
Due to a manufacturing issue, the cab tilt cylinder pin may have been incorrectly welded and could detach from the bracket when the cab is tilted.
Due to a manufacturing issue, the steering rack bolts may become loose or separate. This could result in a loss of steering control.
Due to a software issue, the Electronic Parking Brake (EPB) may not operate as intended. This could result in the vehicle moving or rolling away if the gear selector is not in the…
Due to manufacturing defect, the parking brake lamp on the meter cluster may illuminate when the parking brake lever is released and the vehicle is in motion. This may cause the EZ…
The front axle knuckle may crack due to the high number of high angle turns under axle combined loading (braking and steering) that occur during waste collection. This may result i…
Due to a software issue, the rear-view camera image may be temporarily disrupted when reversing.
The timing belt may degrade due to aged engine oil. If left unrepaired it may result in a reduction or a loss of braking performance.
The Power Sliding Door system may not warn occupants while in operation.
The timing belt may degrade due to aged engine oil. If left unrepaired it may result in a reduction or a loss of braking performance.
Due to a manufacturing defect, the service brake mounting flange was incorrectly positioned prior to welding. This may cause the electric brake to lock.
Due to a manufacturing defect, the drive-by exhaust noise exceeds the limit defined under Australian Design Rule 83/00 (ADR 83/00).
Due to a software fault the Electronic Control Unit (ECU) can be reset when the vehicle switches to electric drive. This will erase stored vehicle fault codes and turn off the chec…
The tyres within this production range may not meet manufacturing specifications which may lead to deflation of the tyre.
Due to a manufacturing defect, certain vehicles may develop a fracture to the mounting bracket at the base of the seat. As a result, the seat base may shift within the seat suspens…
Due to a manufacturing issue, the cab mounting brackets have not been tightened to the designated torque. This could cause the cab lock down mechanism to become loose.
Due to an installation issue, the air conditioning drain hoses may not have been installed correctly and may result in condensation leaking into the vehicle’s interior.If condensat…
Due to an installation issue, the air conditioning drain hoses may not have been installed correctly and may result in condensation leaking into the vehicle’s interior.If condensat…
Due to a manufacturing defect, the High-Pressure Fuel Pump could fail prematurely and introduce failed component debris into the fuel system. This could impair the fuel supply to t…
Due to a software program error, the Battery Management System software may cause the high voltage battery to overheat and/or emit smoke.
Due to an installation defect, the bracket holding the rear entertainment screens mounted in the rear of the front seats, may be incorrectly installed. In the event of an accident…