Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue, certain plug-in hybrid electric vehicles may not have had the High Voltage battery reinforcing plate or battery cover coated with a protective wax. If…
Due to a manufacturing defect, the front axle wiring harness may come in contact with the oil cooler. As a result, the wiring harness may chafe and become damaged over time. This c…
The towing capacity labels found on the driver's side door and tow bar do not match the approved maximum capacities listed in the owners manual.
Due to a manufacturing defect, there is a possibility that the wiring harness retaining bracket on the front drive (R1) axle housing may interfere with the suspension lateral rod i…
Due to a production defect, the wiring harness in vehicles with electrically adjustable rotating seats may become damaged over time due to operation of the seat adjustment. This co…
Due to a manufacturing defect, a plug in the right crankcase cover may become loose. If this occurs, engine oil may leak onto the road and come in contact with the rear tyre. This…
Due to a manufacturing defect, the carpet underlay may be positioned between the nut and the electrical ground stud. If the nut loosens overtime due to vibrations whilst driving, i…
Due to a design defect, the chassis control arm mounts may not meet specifications and could corrode over the life of the vehicle. If the chassis control arm mounts corrode or crac…
Due to an installation issue, certain 7-seat vehicles may have a latch installed with a defective weld in the second-row seat frame which will stop the seat from securing into the…
Due to a manufacturing issue, the vehicle type approval labelling required to be displayed on the engine was not fixed to the vehicle.
Due to a manufacturing defect, under certain conditions the engine may rapidly overheat and subsequently rupture the engine mounted plastic elbow in the cooling system. This could…
Due to a defect during assembly, some vehicles may have the driver’s seatbelt assembled incorrectly. This will reduce the effectiveness of the seatbelt in the event of an accident.
Due to a manufacturing issue, the lower steering shaft attaching bolt may have a torque value lower than the required specification. Over time the lower steering shaft attaching bo…
Due to a manufacturing defect, the pins in the steering bevel gearbox can collapse resulting in increased steering wheel free play or potential loss of steering.
Due to a manufacturing issue, the brake light may remain illuminated when the brake pedal is released. If this occurs, the traffic behind the vehicle will be unable to identify if…
Due to a software issue during a past vehicle software update, the front wheel lift detection component of the DYNAMIC PRO riding mode has been reset to the factory setting of zero…
Due to a manufacturing defect, the fuel pump may have been manufactured outside of specifications. Under certain conditions, if the engine stalls the defective fuel pump may cause…
The ‘Stand Assist’ system which keeps the bike upright when stopped may not release immediately after deactivation as intended. This may prevent the rider from steering, resulting…
Due to a manufacturing defect, the brake disc may have been fitted incorrectly and could detach from the front wheel assembly. This could reduce the expected braking performance.
The product was sold without the warning information that is required for products containing button/coin batteries.
Due to a manufacturing issue, the seat backrest locking mechanisms in the third row may not meet specifications and may fail. In the event of an accident or hard braking the rear s…
Due to a manufacturing issue, the riveting in the airbag deflector bracket may have a sharp edge and could come in contact with the airbag. This could result in a tear in the airba…
Due to a manufacturing defect, the indicator that shows the fuel level may not work as intended. This may result in an incorrect display of fuel level and therefore the driver may…
Due to a manufacturing issue, the fulcrum pin in the optional milled front brake lever may not meet the required specifications. This may result in brakes not working as intended.
Due to a manufacturing defect, vehicles fitted with a panoramic roof may have poor adhesion of the fixed glass panel and front roof panel to the roof frame. As a result, the panora…