Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing defect, brake fluid may leak from the front brake flexible hoses. This could cause the brake fluid warning light to illuminate and may result in reduced brak…
Due to a manufacturing defect, the emergency exit signs are not correctly illuminated as required by the Australian Design Rules (ADR) 44/02.
The tool to mechanically open the spring-loaded parking brake chamber was not supplied with the vehicle.
Due to a manufacturing defect, the water tank brackets could fail resulting in the water tank dislodging from the underbody of the vehicle.
Due to a manufacturing defect, the spline teeth of the windshield wiper arms may deteriorate and could result in loss of wiper function.
The internal circuit board of the remote control for ARB/WARN VR EVO winches can corrode if exposed to water. Corrosion of the remote control’s circuit board may cause the winch’s…
Due to a manufacturing issue, the seat belt pre-tensioner inflator cap may fracture when deployed in the event of an accident.
The front caliper mounting bolts may not meet manufacturing specifications and could loosen. This could result in a reduction or loss in braking performance.
Due to a software issue, some vehicles may experience a thermal overload. If this occurs, vehicle occupants may identify smoke or fire emanating from underneath the vehicle.
Due to a manufacturing defect, the front passenger airbag may not deploy as intended.
Due to a manufacturing defect, small cracks may form in the front lower suspension arms when driving on rough (corrugated) roads. As a result, the suspension may collapse or detach…
Due to a manufacturing defect, the hose connecting fuel tank may become damaged and corroded due to contact against the high voltage battery cover. If this occurs, fuel may leak in…
Due to a manufacturing defect, the interior footwell cover may cause interference with accelerator pedal.
Due to a manufacturing defect, the front seat frame may have been incorrectly welded. As a result, the welded connection could fracture and impair the restraint function of the se…
Due to a manufacturing defect, incorrectly installed rear coil springs may detach whilst driving. As a result, it could lead to a loss of vehicle control.
The electrical wiring of the Heating, Ventilation and Air Conditioning (HVAC) system fan blower may not meet specifications. This could cause overheating and may melt the plastic m…
The Power-Train Control Module (PCM) software determines if the mixture is rich or lean and adjusts the amount of fuel entering the engine. Due to a manufacturing defect, the PCM s…
Due to a manufacturing defect, the driver and passenger side B-pillars plastic cover may have been fitted incorrectly and may detach from the vehicle while driving.
Due to a manufacturing defect, water may enter the rear passenger door latches and cause corrosion in the return spring. As a result, the doors may not latch whilst in closed posit…
Due to a manufacturing defect, the rear tail lamps wiring harness may become lodged between the vehicle body and a foam block. If this occurs, the rear tail lamp may not illuminate…
The spark plugs fitted in vehicle specified do not comply with Australian Electromagnetic Compatibility (EMC) standard AS/NZS CISPR-12.
The brake calliper sliding pin bolts may not have been torqued correctly and could become loose. If this occurs, it may reduce the expected braking performance.
Due to a software issue, the daytime running lamps and automatic operation of the headlights may not operate as intended. This could result in reduced or poor visibility.
Due to a software issue, the instrument cluster may fail to illuminate the visual seat belt warning as required by the Australian Design Rules (ADR) 04/06.
The electrical wiring of the interior fan blower may not meet specifications and could cause excess heat when the highest level of air condition/heater is in operation. This may re…