Every safety recall published by the Australian government, searchable and filterable.
The previous replacement of the rear axle clamping nuts (as part of the recent recall REC-001665) may have caused a misalignment of the rear axle assembly. This could result in exc…
The vehicle's front radar sensor which supports certain driver assistance features, including the Pre-Collision System (PCS) may not have been calibrated during vehicle manufacture…
Due to a manufacturing issue, the transfer case blanking plug may not have been installed correctly during production. This may lead to an oil leak from the transmission.
The steering pivot joint bolts may not meet manufacturing specifications and may become loose. If the joint becomes loose the steering may deviate from its desired trajectory.
Due to a manufacturing issue, the throttle tube may break when excessive lateral pulling force is applied. If this occurs it may result in an unintended acceleration and a loss of…
Due to a manufacturing issue, the Airbag Control Unit (ACU) cover and the Electronically Erasable Programming Read-Only Memory (EEPROM) chip may have been produced with insufficien…
The previous replacement of the rear axle trailing arm clamping nuts (as part of the recent recall REC-001635) may have caused a misalignment of the rear axle assembly. This could…
Due to a software issue some functions of the Mercedes-Benz User Experience (MBUX) multimedia system may not deactivate when the vehicle starts moving. This can result in driver di…
The wiring harness of the fast flash bulb out warning indicator on the dash maybe defective. As a result, the warning light may be triggered even when no bulbs have failed.
Vehicles have been supplied with incorrect information in the owner’s manual in regards to the installation of ISOFIX child restraint system.
The front axle housing may not meet manufacturing specifications and may crack. If this occurs it may result in a loss of vehicle control.
Vehicles have been supplied with incorrect information in the owner’s manual in regards to the installation of ISOFIX child restraint system.
Due to a software issue, the automatic network search of the emergency call system (eCall) communication module may be deactivated. In this case, the automatic and manual emergency…
Due to a software issue related to the internal temperature of the instrument cluster, if the temperature of the instrument cluster is below 32 degrees Fahrenheit (0 degrees Celsiu…
Due to a manufacturing issue, the oil cooler hose may become damaged due to the radiant heat exposure from the exhaust pipes.
To meet the requirements of European towbar regulation ECE 55-01, it is necessary to apply an ECE label to the towbar when fitted to a vehicle. This label was not affixed to the to…
To meet the requirements of European towbar regulation ECE 55-01, it is necessary to apply an ECE label to the towbar when fitted to a vehicle. This label was not affixed to the to…
The steering column mounting bolts may not have been tightened sufficiently and could become loose or separate. This could result in a loss of steering.
Due to a manufacturing issue, the brake tube may become damaged and cause a brake fluid leak. This may result in a reduction in braking performance.
Due to a wiring issue with the airbag system, the airbag may not deploy as intended.
Under certain driving condition the vehicle fail-safe mode may be activated. If this occurs the EV ready lamp will flash accompanied with reduced acceleration and a loss of motive…
Due to a manufacturing issue, the sunroof frame may not have been bonded correctly to the body and could become loose and detach from the vehicle.
Due to a manufacturing issue, the locking mechanism on the front doors may not latch and could remain stuck in the open position.
Due to a manufacturing issue the secondary bonnet latch may be located in the incorrect position, this could prevent the secondary latch from engaging as designed.
Due to the routing of the rear-view camera cable through the trunk lid it may become damaged through repeated opening of the trunk lid. This will result in the rear-view camera not…