Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing defect, the driver and passenger side B-pillars plastic cover may have been fitted incorrectly and may detach from the vehicle while driving.
Due to a manufacturing defect, water may enter the rear passenger door latches and cause corrosion in the return spring. As a result, the doors may not latch whilst in closed posit…
Due to a manufacturing defect, the rear tail lamps wiring harness may become lodged between the vehicle body and a foam block. If this occurs, the rear tail lamp may not illuminate…
The brake calliper sliding pin bolts may not have been torqued correctly and could become loose. If this occurs, it may reduce the expected braking performance.
Due to a software issue, the instrument cluster may fail to illuminate the visual seat belt warning as required by the Australian Design Rules (ADR) 04/06.
The electrical wiring of the interior fan blower may not meet specifications and could cause excess heat when the highest level of air condition/heater is in operation. This may re…
Due to a manufacturing defect, the vehicle's rear driveshaft may fracture resulting in a sudden reduction of motive power.
Due to a manufacturing issue, the steering column shaft could separate from the U-joint. This may result in a loss of steering control.
Due to a manufacturing defect, the differential gear splines inside the Power Transfer Unit may wear out. This could result in a loss of motive power while driving and a loss of th…
The sealing of the firewall panel between the engine and the passenger compartments may reduce over time, allowing moisture to enter potentially causing corrosion in the electrical…
Due to a manufacturing issue, the rear seat back frames were manufactured with thicker ISOFIX wire which may exceed the Australian Design Rule 34 (ADR 34) requirement.
Due to a manufacturing issue, the cab tilt cylinder pin may have been incorrectly welded and could detach from the bracket when the cab is tilted.
Due to a manufacturing issue, the steering rack bolts may become loose or separate. This could result in a loss of steering control.
Due to a software issue, the Electronic Parking Brake (EPB) may not operate as intended. This could result in the vehicle moving or rolling away if the gear selector is not in the…
Due to manufacturing defect, the parking brake lamp on the meter cluster may illuminate when the parking brake lever is released and the vehicle is in motion. This may cause the EZ…
The front axle knuckle may crack due to the high number of high angle turns under axle combined loading (braking and steering) that occur during waste collection. This may result i…
Due to a software issue, the rear-view camera image may be temporarily disrupted when reversing.
The timing belt may degrade due to aged engine oil. If left unrepaired it may result in a reduction or a loss of braking performance.
The timing belt may degrade due to aged engine oil. If left unrepaired it may result in a reduction or a loss of braking performance.
Due to a manufacturing defect, the service brake mounting flange was incorrectly positioned prior to welding. This may cause the electric brake to lock.
The tyres within this production range may not meet manufacturing specifications which may lead to deflation of the tyre.
Due to an installation issue, the air conditioning drain hoses may not have been installed correctly and may result in condensation leaking into the vehicle’s interior.If condensat…
Due to an installation issue, the air conditioning drain hoses may not have been installed correctly and may result in condensation leaking into the vehicle’s interior.If condensat…
Due to a manufacturing defect, the High-Pressure Fuel Pump could fail prematurely and introduce failed component debris into the fuel system. This could impair the fuel supply to t…
Due to a software program error, the Battery Management System software may cause the high voltage battery to overheat and/or emit smoke.