Every safety recall published by the Australian government, searchable and filterable.
The centre stand return spring has been seen to fracture.
There is a possibility that the battery's negative cable is incorrect in length.
The rod connecting the clutch master cylinder and the clutch pedal may break.
Moisture may enter the diesel fuel filter heater at the electric contacts.(Note: The diesel fuel filter heater unit only operates at tempratures below -1° Celcius.)
The main wiring harness may rub against the rear of the frame, causing an electrical fault.
The side stand may bend or break under heavy load while the bike is resting on it.
In some cases, the spare wheel support device might break due to incorrect operation.
The 240V wiring for the power inlet could be damaged by the roof winder cables over time. The defect could cause a short circuit or activation of the electrical safety switch.
The 240V wiring for the power inlet could be damaged by the roof winder cables over time. The defect could cause a short circuit or activation of the electrical safety switch.
In the affected vehicles, if the front tyre(s) are subjected to a large external force such as running over a large pot hole or bump in the road at high speed, there is a possibili…
In the affected vehicles, if the front tyre(s) are subjected to a large external force such as running over a large pot hole or bump in the road at high speed, there is a possibili…
It is possible that the engine wiring harness may chafe on a mounting bracket.
In extreme cases the oil dipstick tube closing plug may leak. It is also possible that the engine wiring harness may chafe on a mounting bracket.
Some combinations of genuine accessory aluminium trays and genuine accessory towbars fitted to the affected Triton model vehicles may not comply with part of the Australian Design…
The fixing bracket of the air unit on the engine may break under the effect of vibrations.
Should an error with certain interfacing systems be detected, the cruise control system will be disabled and an error message displayed to the driver on the instrument cluster. Sho…
In extreme cases the oil dipstick tube closing plug may leak.
The spare wheel carrier assembly installation is incomplete, whereby two welds connecting the spare wheel carrier support beam to the chassis rail may not have been included in the…
The fuel return pipe fitted to the vehicle could separate and allow fuel to leak under the vehicle.
The box may accidentally detach from the motorcycle.
There is the possibility that the fuel supply line can come into contact with the heat shield in the engine compartment. This could cause damage to the fuel supply line, which in i…
The ground terminal of the windscreen wiper motor may have been inadvertently bent during the assembly of the windscreen wiper motor. This may cause a loss of the electrical ground…
Insufficient clearance between the seat belt and seat base cushion.
It is possible that one of the circlips that retain the piston pins within the pistons has been incorrectly installed.
There is an internal non-conformity of both front seat backrests.