Every safety recall published by the Australian government, searchable and filterable.
The stone chipping resistant agent sprayed to the underside of the vehicle may have been applied where rear torsion axle retaining bolts are located.
The amount of adhesive agent applied between the outer ring and torsional rubber damper of the crankshaft pulley may be insufficient.
The wire harness was not routed in the correct location.
The coolant pump for the exhaust turbocharger may fail due to a defect in its printed circuit board.
Victory has determined that the backrest support bracket on some of these accessory seats can fail and allow the passenger backrest to separate from the seat base.
Victory has determined that the backrest support bracket on some of these accessory seats can fail and allow the passenger backrest to separate from the seat base.
Non compliant brake pads may have been incorrectly installed on the vehicle.
A faulty brake light switch may lead to the cruise control not disengaging when tapping the brake pedal. The cruise control can still be disengaged via the cruise control lever or…
The affected model motorcycles may experience a non-functioning stop light and/or cause brake fluid to leak through the rear stop light switch, affecting rear brake performance.
The evaporative valve purge harness may not be secured properly and could lead to the harness becoming damaged.
Abnormally high oil pressure may build up inside the oil pump. This may cause the oil pump to malfunction.
Early wear on the auxiliary belt tensioner.
Early wear on the auxiliary belt tensioner.
The electric power-assisted steering may disengage. The mechanical steerability of the vehicle will be maintained at all times, however.
In isolated cases, the second stage of the front passenger airbag may not deploy as designed. The first stage of the airbag will in all situations remain fully operational, however…
Due to insufficient tensioning of the steering bevel lock-nut on affected trucks within the VIN range, there is the possibility that the lock-nut may loosen.
Early wear on the auxiliary belt tensioner.
In the event of a side impact, the vehicle may not perform to the manufacturer's required specifications.
The injector lines may crack, resulting in fuel leakage.
On some Fiat Scudo vehicles, the wiring for the power steering electric pump might interfere with one steel edge of the left front wheel arch and become damaged due to a possible l…
The backrest support on some of these accessory seats may be defective.
Incorrect machining of rear tie-rods.
The backrest support on some of these accessory seats may be defective.
The driver's side power window switch contains a switch unit that has been manufactured with an inappropriate design. Therefore, it is possible for automotive cleaning products con…
Incorrect engine management calibration.