Every safety recall published by the Australian government, searchable and filterable.
The front suspension wishbone bolts may not be to the correct specification.
In the event of an accident, the airbag igniter may cause inadequate inflation of the driver, passenger and/or seat airbag units on the affected vehicles.
The rear suspension leaf springs may not conform to the required standard.
The wiring harness connector pins in the Hydraulic Electronic Control Unit (HECU) assembly may corrode due to improper sealing of the HECU’s wiring harness connector. An electrical…
The sensing and diagnostic module (SDM) in these vehicles, which controls airbag and pretensioner deployment, contains a software defect which may prevent the deployment of frontal…
Contact may occur between the wiring harness and the ABS modulator due to deviations in the assembly process. This will only occur if the wiring harness is frayed and in contact wi…
In the event of an accident this may result in the front passenger airbag not deploying resulting in an increased risk of injury.
There is a possibility that an intermittent Output Shaft Speed Sensor failure may result in an unintended downshift into first gear.
Software errors in the engine control unit (Digital Motor Electronics-E) can cause a faulty setting of the idle controller. In some cases, this can result in the engine stalling wh…
Lexus NX vehicles are equipped with a brake hold function which keeps the brake applied after the vehicle comes to a complete stop. Under certain conditions, the system is designe…
The main switch wire lead is routed near a metal cable guide located on the steering head. Through normal use, there is a possibility that the wire lead may be worn by the metal gu…
The front shock absorbers can be damaged if the vehicle is driven in specific extreme conditions for extended periods of time.
The laser welded seam on the front seat backrests may not have been correctly configured during production, which may impact on the strength of the welded connection.
Incorrect software coding within the rear control unit may result in the seatbelt handover arm not retracting when the vehicle is moving. In the event of an accident this may impai…
If moisture and dust get in between the electrical guide ways on the lamps Printed Circuit Board (PCB) or between the reflector and the PCB it could lead to a 'soft' short circuit.
The plastic fuel pump retaining rings on the fuel tank may be exposed to heat from the engine and exhaust pipes due to insufficient thermal insulation, causing heat deterioration o…
The plastic fuel pump retaining rings on the fuel tank may be exposed to heat from the engine and exhaust pipes due to insufficient thermal insulation, causing heat deterioration o…
The steering arm may fail under extreme operating conditions.
It has been found that out of specification adjustments can be made to the tie rods during a wheel alignment. This can cause them to be adjusted to an unsafe thread engagement betw…
If the vehicle is involved in a frontal or rear-end collision, the crash data may not be evaluated correctly by the vehicles airbag central sensor and this may lead to the passive…
The specified model may have had the fuel rail crossover tube damaged during the engine manufacturing process.
The bracket attaching the secondary steering gear to the chassis may fracture if the bolt tension is not regularly checked.
Mitsubishi Motors Corporation has identified that insufficient anti corrosion coating was applied to the end cap on the outer tube of the tailgate gas springs, and this may result…
The affected vehicles have tyre valves fitted that could be defective, resulting in a loss of tyre pressure.
The fuel tank band fixing bolts may not be tightened to the correct torque specification.