Every safety recall published by the Australian government, searchable and filterable.
Some MY2018 111 ci motorcycles have been manufactured with a right-hand switch cube that does not meet quality standards. Affected switch cubes may develop corrosion within the Sto…
The seatbelts for the rear left and right seating positions may have been installed incorrectly.
The cable length of the rear door lock assemblies may be out of specification. As a result an active child lock can unnoticeably be inactive. This may lead to the rear doors being…
Due to an incorrect setting in the software of the Body Control Module (BCM) in affected vehicles, the system may not trigger a warning (double speed flashing) in the case of an in…
In affected vehicles the wiring loom may touch the clutch pipe. In a worst case scenario the clutch pipe may rub through the wiring loom insulation creating a short circuit that ma…
A machining defect of the primary drive and driven meshing gears results in excessive noise during acceleration and engine rpm increase when shifting through gear ratios. This is d…
Part of the aluminium trim strips in the loudspeaker of the front or rear door trim may become detached.
In some Model S vehicles when exposed to long-term, high-corrosion environments, the aluminum bolts that attach the power steering gear assist motor to the gear housing may corrode…
Under certain environmental conditions the PowerNet Distribution Box (PNDB) module can go into auto-reset mode.
Affected vehicles are equipped with a vacuum pump that provides vacuum for the brake booster operation. A lubrication passage inside the vacuum pump may have been compromised durin…
A deeply contoured weld seam on the rear axle housing was not welded correctly during the production process on certain vehicles of the Actros model 963 and Arocs model 964.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a coll…
The right hand door locks may not be to the manufacturer's specifications. The internal mechanism of one or more locks may jam, which could prevent one or more doors from closing o…
The door locks may not be to the manufacturer's specifications. The internal mechanism of one or more locks may jam, preventing one or more vehicle doors from closing or result in…
A manufacturing fault may cause the steering wheel assembly and column to separate.
The linkage that controls the fresh air flap in the heating system may become disconnected. When the right atmospheric conditions exist, condensation may form on the front windscre…
The steering column clevis nut on the steering rack tail may not have been tightened to the correct specifications.
The WK Jeep Grand Cherokee tow bar kit has bolts and washers that may lose torque during towing.
A correct Stationary Noise Data Label was not fitted in production (as required by Australian Design Rule ADR 83).
Some engine mounted fuel rails installed on Ingenium I4 2.0L petrol engines have not been manufactured correctly, with a risk of fuel vapour and liquid leaks occurring within the e…
Some engine mounted fuel rails installed on Ingenium I4 2.0L petrol engines have not been manufactured correctly, with a risk of fuel vapour and liquid leaks occurring within the e…
If a bent or broken spring obstructs the clearance of the spindle in the starter motor relay, it can lead to a blockage over time and result in a permanent current supply to the st…
In affected vehicles the electrical lines of the jump-start socket may have been connected incorrectly. When a further vehicle is connected for the purpose of starting assistance,…
The water pump may experience a failure which may result in an engine compartment fire.
The Brake Transmission Shift Interlock (BTSI) locking pin may become stuck in the open position. A BTSI locking pin stuck in the open position may allow the transmission to be shif…