Every safety recall published by the Australian government, searchable and filterable.
The motorcycle side stand connection might bend or break.
There is a software error in the tyre pressure monitoring system (code RY2) of some X-Class vehicles. If the tyre pressure falls below the minimum level, the warning message may no…
A deformed clutch cable clamp may contact the bottom plate of the fuel tank.
The swivelling of the front seats may cause the wiring loom fasteners to detach under the seat.
The transmission oil lines may have been manufactured outside of specification.
Hoses may melt in the bike lower left area (under the battery) due to interference of the fuel tank and air box drain hoses with the horizontal cylinder exhaust manifold.
Some spot welds on the front side wall joining the door frame with the hinge reinforcements may not have been applied. This may affect the driver's side and/or the front passenger…
A fault in the Power Control Module (PCM) software may affect cruise control, potentially causing the vehicle speed to lock or unexpected vehicle acceleration.
A fault in the Power Control Module (PCM) software may affect cruise control, potentially causing the vehicle speed to lock or unexpected vehicle acceleration.
Vehicles were manufactured with front axles that do not have the correct width requirements.
Computer software for the Power Control Module (PCM) is faulty. In certain circumstances this may affect cruise control and the possible locking of speed or cause acceleration of t…
The fuel pump harness connector on affected vehicles may deteriorate over time. This may lead to the non-operation of the fuel pump, causing extended engine cranking time on start…
Models equipped with Anti-Lock Brakes (ABS) may experience decreased brake performance resulting from the presence of air in the brake circuit. This may cause a soft brake lever/pe…
A low cell voltage condition in the battery pack may cause the vehicle to experience a reduction or loss of forward movement, or not start. A warning light will be shown on the in…
Computer software for the Power Control Module (PCM) is faulty. In certain circumstances this may affect cruise control and the possible locking of speed or cause acceleration of…
The engine in affected vehicles may stall without warning under certain driving conditions (accelerator pedal released and below 2000 rpm in conjunction with automatic shifts from…
The rear brake pistons may have been coated incorrectly, potentially causing increased brake pedal travel and reduced braking effectiveness.
The electrical circuits in the left-hand switch cube may not function correctly due to an incorrect seal. If water penetrates the seal, the turn signal indicator and headlamp contr…
Moisture may enter the electronic components and cause overheating and failure of the additional coolant pump.
Due to a possible electrical connection failure to the cars main battery power cable where it connects into the vehicles fuse box, the car may lose power to several electrical syst…
The electrical wiring and the fan resistor for the vehicle's interior fan blower motor may deteriorate over time.
On MY18 Volkswagen Polo models of a limited production period, the belt buckle on the rear left seat can inadvertently become undone.
In certain operating conditions vehicles equipped with a SPL250 driveshaft and specific Meritor rear axles may experience rear axle yoke failure potentially causing the driveshaft…
The software that controls the power sliding door may not detect certain obstructions. As a result the power sliding door may not auto-reverse when an obstruction is in the door op…
In heavy rain the seals of the front doors may allow water to enter the door cavity.