Every safety recall published by the Australian government, searchable and filterable.
Due to improper assembly of an oil seal in the automatic transmission, fluid may leak from the transmission which could result in a loss of drive.
Due to a manufacturing issue with the anti-lock braking system (ABS) module it is possible that excess grease may adhere to internal components. Continued use of the motorcycle, wi…
Due to a manufacturing issue with a braking component the Anti-Lock Brake System (ABS) and Electronic Stabilisation Control (ESC) function may fail under hard braking.
On some vehicles, it has been identified grease was not applied to the slide pins of the front wheel brake calipers. If the outer Brembo brake pad is continually used under the def…
Due to a manufacturing issue, the park brake lever may fracture and fail. If this occurs whilst applying the park brake the parking brake may not engage, this could result in unint…
The ABS connectors to the rear brake valves may have been incorrectly fitted. This will lead to a reduction in brake performance.
On MY22 bikes the front brake caliper locking split pins used to mount and secure the front brake pad holding bracket may have been fitted in the wrong direction.If the locking pin…
On MY21 and MY22 bikes the front brake caliper locking split pins used to mount and secure the front brake pad holding bracket may have been fitted in the wrong direction.If the lo…
The piston rings assembled in engines may be defective, which can cause damage to the piston rings and cylinder bore.
The vacuum pump which supports brake assistance (brake boost) may become damaged under certain engine start conditions caused by the engine management software. This may cause a re…
The lock nut at the strike button on the portable fire extinguisher may not be mounted. If the fire extinguisher is activated and no lock nut is present, the strike button assembly…
Due to improper assembly of the oil pressure relief valve it may fail and the engine may become insufficiently lubricated. This may result in a reduction of engine performance and…
The panel located between the windshield and the panoramic sunroof of your vehicle may not have been bonded correctly during a prior service repair. The bonding might deteriorate g…
The rear axle housing may not meet manufacturing specifications and may fail. If this occurs it may cause the rear wheel to lock up and result in a loss of vehicle control.
Some nuts fitted to the rear axle assembly did not meet manufacturing specifications and may break. A broken nut may lead to increased movement between the wishbone and hub carrier…
The software of the braking program installed on certain trailers between January 2010 and May 2016 was incorrectly programmed. Incorrect programming may hinder braking performance…
A component within the brake assembly may not meet manufacturing specifications. . If the component is not manufactured correctly the brake calliper will not operate correctly, the…
Due to incorrect software parameters within the Chassis Control Module, there may be a delay in the intervention of the Electronic Stability Control (ESC). This may result a loss o…
The prime mover air brake system may not comply with the Australian Design Rule (ADR). In the event of a total trailer air brake system air loss, the prime mover and trailer brakes…
The plastic horn pad logo may become brittle and fracture during an airbag deployment.
Due to a software fault in the power electronics control unit, a loss of motive power might occur while driving.
The fuel injector return pipe may not meet manufacturing specifications and may split. A split fuel return pipe will allow fuel to leak into the engine bay and onto the road.
The fuel pump on affected vehicles may stop operating. If the fuel pump stops working, warning lights and messages may display on the instrument panel, and the engine may not run…
A crack may occur on the cylinder contact surface in the engine, the piston may be damaged or seize during the vehicle’s service life. This could cause the piston to get jammed in…
The sealing of the high-voltage battery housing may reduce overtime, allowing moisture to enter. The moisture may result in the corrosion of the battery potentially resulting in an…