Every safety recall published by the Australian government, searchable and filterable.
Due to a software issue in the Body Control Module (BCM), the Headlamp and the Daytime Running Lamps (DRL) may remain illuminated simultaneously for 60 seconds when using the Remot…
Due to a manufacturing issue, the connection of the horn to the frame of the motorcycle could become loose and may detach. As a result, it could fall downwards and prevent the ride…
Due to a manufacturing issue, the alternator wiring and the electric steering wiring may not be installed correctly. The wiring harness could be damaged due to being overloaded and…
Due to a software issue, the Lane Tracing Assist (LTA) steering feature may not operate as intended. This may reduce the level of maintaining the vehicle’s position in the centre o…
Due to a manufacturing defect, the fuel feed hose may become chafed and could cause a fuel leak in the engine compartment. This may result in a vehicle fire.
Due to a manufacturing issue, the wiring harness may become damaged and could result in function failures, or a short circuit. This could cause a vehicle fire.
Due to a manufacturing defect, the valve between the engine and the vacuum assist brake booster may swell under certain conditions. As a result, an increased brake pedal effort may…
Due to a manufacturing defect the transmission wiring harness may be damaged. The damage can allow moisture into the wiring harness, which may cause a short circuit resulting in a…
Due to a manufacturing defect in the vehicle’s trailer connection electrical components, the trailer stop lamps may not operate as intended. This could result in road users being u…
Due to a manufacturing defect, the hydrogen gas detection sensors may deteriorate over time. This may lead to a failure to detect gas leaks and illuminate the warning light to the…
Due to a software fault in the vehicle’s Electronic Control Unit (ECU) the engine may stall resulting in an unexpected loss of vehicle control.
Due to a manufacturing defect, the valve between the engine and the vacuum assist brake booster may swell under certain conditions. As a result, an increased brake pedal effort may…
The design of the rear wall cabinets is not sufficient to ensure their integrity is maintained in the case of a frontal collision.
Due to a manufacturing issue, the transmission wiring may have been routed incorrectly and may contact the front driveshaft. This may result in an unexpected loss of traction.
The piston rings fitted to certain vehicles may not meet manufacturing specifications and could cause engine failure and vehicle stalling. This will result in an unexpected loss of…
The front suspension torsion bar may not have screwed into the torsion bar linkage as per specifications. This could cause reduced stability while driving at high speed and result…
Due to a manufacturing issue, the rear wheel bearing housing may fracture. If this occurs it could result in loss of vehicle control.
The connection depth of the front towing point may not meet manufacturing specifications. As a result, the front tow point connection could detach from the vehicle during frontal t…
Due to a manufacturing defect, the driveshaft universal joint play may exceed the manufacturer's tolerance. If the vehicle continues to operate under these conditions, grease may l…
Incorrect front and rear covers were used during manufacturing process of the vehicle owner’s manual and therefore the content provided does not match the vehicle.
Due to a manufacturing defect, the high voltage battery does not meet specifications and may result in an electrical short circuit. If this occurs it may result in a vehicle fire.
Due to a manufacturing issue, the wheel hub assembly and suspension may collapse or detach from the vehicle. If this occurs the vehicle may experience a sudden loss of steering con…
Due to a manufacturing issue, the seat belt pre-tensioner inflator may fracture when deployed in the event of an accident.
Due to a manufacturing defect, the front axle brake line hose(s) may become dislodged from the end fitting crimp. This may cause a reduction in braking performance or an unintended…
The reverse lamps may not illuminate and the rear-view reverse camera may not display the rearwards image when reversing as intended.