Every safety recall published by the Australian government, searchable and filterable.
The Power Distribution Center (PDC) may overheat, causing a loss of function of the Antilock Brake System (ABS) and/or Electronic Stability Control (ESC).
The right side power liftgate pinch sensor may not function as intended, resulting in an increase in force required to stop the power liftgate during the final closing stages.
There is a possibility that a sensor that forms part of the vehicle's supplemental restraint system may not have been secured.
Inappropriate installation and operation of the power seat harness in the driver’s power seat.
Due to to use of inferior brake-pad material, the rear brake may not function adequately under heavy braking.
The Cummins ISMe5 engine software can allow the engine to operate without the use of diesel exhaust fluid.
A pin securing the brake pedal connecting rod could disengage and eventually fall off. This could cause a total loss of main brake function without prior warning.
Engine oil from the brake vacuum pump may enter the brake vacuum line. In some cases, it is possible that after a period of time oil may enter the brake booster.
The turbo cooling pump housing may crack, causing engine coolant to penetrate the electronics of the pump. This could lead to an internal short circuit and subsequent failure of t…
BMW Motored has found that there have been a few, isolated cases of engine damage occurring at high engine rpm. This was caused by conrod bolts working loose.
The additional coolant pump for the exhaust turbocharger may fail. This may cause overheating and scorching of the coolant pump.
Due to an assembly error, the battery cover may not have been correctly clipped to the floor panel. This may cause loosening of the positive terminal cable connection.
A production error has occurred with the installation of the fuel filler pipe hose clamp.
A misalignment in the welding of the right lower control arm and the sub frame push collar inside the vehicle may cause the welded area to break.
The brake lines may develop a leak due to an issue with the material used for the inner liner.
If the window air bags are deployed during an accident, the ‘A’ pillar trims may dislodge from their mountings.
The rear lights may not be in conformance and therefore not function properly.
There may be insufficient clearance between the engine cover assembly and the fuel return hose.
The window sashes may separate from the window frames under extreme conditions.
There is a possibility that a prototype instrument panel reinforcement has been installed on certain RAV4 vehicles.
Excessive heat within the circuit board and uncontrolled electric current output may result in insufficient charging to the motorcycle battery.
The wiring harness under the driver and/or passenger seat may not have been properly affixed to the seat frame during vehicle assembly. As a result, the harness connector may deta…
It is possible that the headlight module may not be locked correctly, resulting in the headlight becoming detached from the wing of the car.
The rear wheel of the motorcycle may develop structural problems due to a non-conformity with the fabrication standards.
The Occupant Restraint Controller (ORC) module may have been contaminated by water leaking from the Heating, Ventilation and Air Conditioning (HVAC) drain grommet. Water in the OR…