Every safety recall published by the Australian government, searchable and filterable.
It is possible that the engine crankshaft pulley has not been manufactured to correct specifications and may disintegrate during operation.
There are two defects to be remedied:(1) The left side of the driver’s side seat slide mechanism may not lock as intended and may allow the driver's seat to move forward in a sever…
Turbochargers which did not conform to quality standards were installed in the affected cars.
The transmission skid plate on the 2010 JK Jeep Wrangler may allow debris to collect around the catalytic converter.
The affected vehicles may have been insufficiently arc welded at the steering wheel boss where it connects to the main steering wheel frame.
Toyota Hiace Van and Commuter vehicles equipped with the 1KD-FTVdiesel engine may have two potential issues:(1) The Exhaust Gas Recirculation (EGR) system pipes may not be able to…
There is potential for a coolant leak to develop from the heater core. Leaking coolant may enter the ECU and cause a short circuit. In the worst case scenario the SRS airbag could…
Toyota Hiace Van and Commuter vehicles equipped with the 1KD-FTVdiesel engine may have two potential issues:(1) The Exhaust Gas Recirculation (EGR) system pipes may not be able to…
The front seat belt mounting brackets may fracture during normal vehicle usage.
Holden has initiated a vehicle safety recall on certain Holden Cruze 1.4 Litre turbo petrol engines due to a potential for spilt oil to pool on the lower air deflector.
Due to an incorrect heat treatment process, the inner tubes for the front forks may crack.
There have been reports of breakage of the steering damper clamp on 3 vehicles in other markets.
During the fitting of the tow ball, the securing nut may have had insufficient torque applied. This could cause the securing nut to come loose. In the worst case, the tow ball co…
The waterproof seal inside the speed sensor may break down, which could cause the speedometer to cease functioning.
On affected vehicles, one of the components of the hydraulic ABS/ESP block may have a non-conformity in comparison to the manufacturer's required specifications.
Some motorcycles may have been fitted with the incorrect retaining bolt linking the swingarm to the rear suspension linkage rod.
The Hill Start Aid (HSA) may fail to activate.
The park brake may engage by itself on trailers fitted with these parts.
Isuzu Motors Japan have identified that the tie rod may impact the the I-beam during operation.
Suzuki Motor Corporation has identified that securing bolts of the side stand switch body may loosen due to temperature expansion and contraction which results in the reduction in…
A bolt within an isolator may vibrate loose and unscrew, thereby coming into contact with the starter power cable and potentially creating a short circuit from the starter motor po…
The horn may fail to operate due to the mis-routing of the electrical harness inside the steering wheel pad.
A production error occurred during installation of the fuel filler pipe hose where it attaches to the body-mounted fuel filler pipe.
The thread of the hub drum fixing nuts may not meet specifications. As a result, the hub drum fixing nuts may not tension correctly.
A machining fault may cause crankshaft failure.