Every safety recall published by the Australian government, searchable and filterable.
On affected vehicles, the striker wire support on the bonnet lining may not be sufficiently secure. This may allow the bonnet to open while the vehicle is in motion.
Due to insufficient rigidity, under certain limited conditions the lower edge of the rear right wheel arch protector may become deformed. In conditions such as high speed and high…
The gearshift cable retaining clip may not be securely fastened, which could lead to the gearshift cables making contact with the rear driveshaft.
The gearshift cable retaining clip may not be fully engaged, which could lead to the gearshift cables moving out of position and contacting the propeller shaft.
The steering column has no electrical connection to ground other than the spiral cable.
There is a possibility that an engine oil-way blanking plug may become dislodged.
The driver is not alerted to low air pressure in the braking system because the air system warning is set too low.
The front brake mounting hardware may have been under torqued and the incorrect torque tool used during manufacture.
The propellant mix of certain right rear (driver's side rear) seat belt tensioner squibs may not meet the specifications.
On some heavy-duty trucks with rear tandem-axle and leaf suspensions, the shape of the radius rod brackets mounted to the trunnion cross member is incorrect. The input from the rad…
The Exhaust Gas Recirculation (EGR) pipe may break due to a potential non-conformity.
A power relay may overheat, resulting in a relay failure.
If the engine misfires for a prolonged period of time, the exhaust could get hotter than normal and melt a retention clip that supports the rear brake line increasing the risk of b…
On affected vehicles the screw/bolt in the range group catch bolts may come loose.
On certain 2016 and 2017 Model X with fold-flat second row seats, the left-side fold-flat second row seat may have a misadjusted cable that controls the recliner mechanisms. These…
A weld seam has been improperly applied to out-of-line axle housings during the production process.
The affected Power Relay/s may generate excessive heat, resulting in relay failure. As a result, the engine may stall during driving, fail to restart or failsafe protection may be…
The ball joint(s) could be damaged in vehicles with high mileage or vehicles exposed to specific severe conditions.
The fastening nut from the drive pulley on the CVT has been insufficiently tightened due to an improper tightening method and incorrect tightening torque.During assembly, soldering…
If the starter were to become blocked due to prior damage and if multiple and/or extended start attempts were to be made in this condition, the starting current limiter could be el…
The propellant mixing ratio of certain front right (driver) seat belt tensioner squibs may not meet the specifications.
If cargo contacts the underside of the subwoofer that protrudes into the boot area in certain MY15 WRX and WRX STI vehicles, an electrical short circuit may be created and this may…
The propellant mixing ratio of certain passenger seat belt tensioner squibs may not meet the specifications.
The engine of affected vehicles may turn off when braking at a low speed (e.g. when braking for a traffic light).Also, after an ECO start, the engine may turn off again if the vehi…
Manufacturing defect in the fuel feed hose assembly that could result in a fuel leakage.