Every safety recall published by the Australian government, searchable and filterable.
The bonding for the lower area of the windshield may not comply with the specifications. In the event of an accident, the windshield could separate from the body in the affected ar…
The Brake Transmission Shift Interlock (BTSI) locking pin may become stuck in the open position. A BTSI locking pin stuck in the open position may allow the transmission to be shif…
The software that determines the classification of the front passenger may not function correctly. This may result in an installed child seat being identified as a person, or a sma…
On the affected vehicles, it is possible in some circumstances that when the right side front seat is operated to its fully rearward position that the seat runner can compress the…
On the affected vehicles, it is possible in some circumstances that when the right side front seat is operated to its fully rearward position that the seat runner can compress the…
The subject vehicles are equipped with a resin fuel tank that contains a resin fuel inlet pipe. There is the possibility that the resin weld between the fuel tank and the fuel inle…
Some replacement passenger front airbag inflators installed in MY 2004-2007 Impreza vehicles as part of the current Takata recall campaign (SI0277) may have been installed incorrec…
If driven across areas covered by high dry grass, there is a possibility that grass or vegetation could become trapped and accumulate in the vehicle underbody area.
If driven across areas covered by high dry grass, there is a possibility that grass or vegetation could become trapped and accumulate in the vehicle underbody area.
An internal failure in the Occupant Restraint Controller (ORC) may result in the inability to deploy an Active Headrest (AHR) function during certain rear-end crashes.
The holes in the rear shock absorber tie-rod frame mounts could become elongated if the rear shock absorber bottoms out.
The primary fixed sheave nut may loosen during riding due to inadequate tightening torque of the nut. If the nut loosens off, the primary sheave may contact the crank case cover, c…
A defect in the fuel cap seal may allow fuel to leak from the fuel tank, or water to enter the fuel tank.
The brake booster water shield may have been incorrectly installed during completion of Safety Recall P14. This may cause the brake booster water shield to be less effective in di…
The steering column has no electrical connection to ground other than the spiral cable.
On certain 2016 and 2017 Model X with fold-flat second row seats, the left-side fold-flat second row seat may have a misadjusted cable that controls the recliner mechanisms. These…
The ball joint(s) could be damaged in vehicles with high mileage or vehicles exposed to specific severe conditions.
If the starter were to become blocked due to prior damage and if multiple and/or extended start attempts were to be made in this condition, the starting current limiter could be el…
If cargo contacts the underside of the subwoofer that protrudes into the boot area in certain MY15 WRX and WRX STI vehicles, an electrical short circuit may be created and this may…
Manufacturing defect in the fuel feed hose assembly that could result in a fuel leakage.
Defect in the parking brake switch that could fail to alert the driver when the park brake is still engaged.
The airbag initiators within the side airbag modules may contain an incorrect chemical mixture.
The airbag initiators within the side airbag modules may contain an incorrect chemical mixture.
There is a possibility that an incorrect specification airbag assembly was installed during the vehicle assembly process.
The airbag initiators within the side airbag modules of certain Ranger and Everest vehicles may contain an incorrect chemical mixture.