Every safety recall published by the Australian government, searchable and filterable.
When the handlebar is turned from side to side, the brake hose comes in contact with the horn lead wire due to incorrect positioning.
Vehicles with an auxiliary battery installed under the front driver seat may not include a seat base cover, which may result in the seat base being used as a storage compartment, w…
The scooter's main stand may crack and break due to substandard welding.
The bracket supporting the front brake hose may dislodge, causing friction between the brake hose and the front fork, resulting in brake fluid loss.
The side stand spring may fracture whilst the side stand is disengaged.
Due to incorrect installation, the genuine accessory towbar wiring harness (where fitted) may allow liquids to contact the electrical circuits. This may cause the harness and its s…
The exhaust gasket at the turbo/exhaust pipe join and at the exhaust pipe/aftertreatment device join may not have been installed. An audible and visual exhaust leak may be detectab…
The vehicle's rear axle steel leaf springs may not meet the required level of strength during operation and may break during use.
When the hydraulic system for the power steering is under a high pressure load, or when the steering is in full lock, or if there are heavy vibrations due to uneven road surface, t…
As a result of excessive movement and vibration, the fuel pipes under the vehicle may become damaged, resulting in a diesel fuel leak.
The steering gear box fastening screws may be missing, fitted with incorrect extended screws or non-original screws have been installed that may be loose.
Due to the improper plating on the moveable contacts on the horn and starter switch, if continuously used, dust or water could enter the switch block, which could lead to corrosion…
Due to improper assembly of the electrical contacts in the seat belt reminder switch, the driver's seat belt reminder system may fail to switch off after repeated use of the seat b…
The gear shift lever may become loose from the ball joint, resulting in excessive movement at the end of the shift lever.
The vehicle's tie rod end may prematurely fail due to dry steering.
Due to an improper manufacturing process, the vehicle side stand may break.
If the glass pane protrudes from the vehicle, wind noises may develop and, if unnoticed, the glass pane may over time fully detach from the vehicle, which would increase the risk o…
Due to incorrect manufacture, in the event of an accident one of the two locking mechanisms in the vehicle's rear seat belts may not lock the seat belt as designed.
The transmission harness may have insufficient clearance to the catalytic converter.
The transmission harness may have insufficient clearance to the catalytic converter.
Affected vehicles may be fitted with a Takata NADI 5-AT driver airbag inflator that could allow moisture to enter the unit and degrade the airbag propellant. If this occurs, the pr…
A clip on the fuel hose bundle may rub on the fuel pump return hose, which could cause a fuel leak.
The plastic spacers fitted between the fuel rail and cylinder head may expand and contract, which can cause a reduction in the clamping force of the bolts securing the fuel rail to…
Affected vehicles may be fitted with a Takata NADI 5-AT driver airbag inflator that could allow moisture to enter the unit and degrade the airbag propellant. If this occurs, the pr…
Due to a software programming fault, the engine may not restart after entering idle stop mode until the vehicle is restarted using the Start/Stop button.