Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing defect with a weld on the transmission mount, the connection between the transmission and propeller shaft may become separated. As a result, the vehicle may…
Due to a software error, the tail lamps on one or both sides may not illuminate as intended. If this occurs during dark conditions, the traffic behind will have reduced visibility…
Due to a manufacturing issue, the seat backrest locking mechanisms in the third row may not have been installed correctly and may fail. In the event of an accident or hard braking…
Due to a manufacturing defect, the front passenger and driver seat belt service parts used as replacements on certain vehicles may not operate as intended and could extend further…
Due to a manufacturing defect, diodes may have been soldered to the printed circuit board, instead of transistors, in accelerator pedals during assembly. In the event of voltage pe…
Due to a production error, the seat frame’s mounting bolts for both front seat belts may not have been tightened according to specifications and could become loose. As a result, th…
Due to a recently changed software calibration issue, the Electronic Power Assist Steering system (EPAS) may not operate as intended. This may result in a reduced or loss of power…
Due to a manufacturing defect, the right-hand front wheel speed sensor wiring routing may have been installed incorrectly during assembly. As a result, the brake fluid hose or the…
A software programming error in the Engine Control Module may cause the combustion engine to not restart whilst driving. This condition, with a depleted High Voltage battery, could…
Due to the wiring harness routing at production, it may result in rubbing or chaffing of the wiring harness at frame contact points. As a result, the wiring harness may become dama…
Due to a manufacturing defect, the high voltage battery may not meet specifications and could discharge or in some instances lead to a vehicle fire.
Due to a manufacturing defect, the high voltage battery may not meet specifications and could discharge or in some instances lead to a vehicle fire.
It is possible when opening the trunk lid, water may enter through after heavy rain or use of a high-pressure cleaning device. As a result, moisture could enter and may cause a sho…
Due to a manufacturing defect, the seat belt monitoring system may not indicate the seat belt status of the occupants as intended. As a result, there may not be a warning when the…
Due to a manufacturing issue, the airbags inflatable curtain inflators may rupture without warning.
Due to a manufacturing defect, the position light and flasher electrical harnesses in the front fenders may become loose and rub on the tyres. This could lead to a short circuit an…
Due to a manufacturing issue, the airbags inflatable curtain inflators may rupture without warning.
Due to a manufacturing issue, the clutch cover screws may become loose. If this occurs, engine oil may leak onto the road and come in contact with the right side of the rear tyre.…
Due to the vehicle design, servicing certain components requires disassembly of the second row left seat belt buckle and centre seat belt anchor, both of which are fastened with th…
Due to a software issue, the brake light may remain illuminated when the brakes are not applied. If this occurs, the traffic behind the vehicle will be unable to identify if the mo…
Due to a manufacturing defect, the bonding between the driveshaft and the engine/transmission flange may not be secured as intended. This could cause the connection to detach and r…
Due to a manufacturing issue, the radiator on some vehicles may not be properly secured. This could cause the radiator to move and may result in the loss of engine coolant. A loss…
The vehicle jack provided with certain vehicles may be faulty and also may not meet the requirements of the Australian Consumer Product Safety Standard. If a faulty vehicle jack is…
The vehicle jack provided with certain vehicles may be faulty and also may not meet the requirements of the Australian Consumer Product Safety Standard. If a faulty vehicle jack is…
Due to a manufacturing defect, the engine oil cooler lines may become damaged due to a contact point with the two cooler lines and may cause an oil leak. If this occurs, oil may le…