Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue, the Continuously Variable Transmission (CVT) inhibitor switch may not be sealed sufficiently allowing moisture to enter potentially causing corrosion…
The front drive shaft may not meet manufacturing specifications and the outer race of the front driveshaft may crack. If this occurs, the vehicle will stop operating while in motio…
Due to a software defect, a warning message that indicates when the Automatic Clutch Unit (ACU) motors require replacement may not operate as intended. This may cause the ACU to st…
The coupling may fail when a vertical load of three tonne is applied to the coupling head and may result in the trailer detaching from the tow vehicle.
Due to a software issue in the Engine Control Unit (ECU), the Selective Catalytic Reduction (SCR) system may not operate as intended. If this occurs, the instrument panel warning l…
The Diesel Particulate Filter (DPF) may crack due to overheating. If this occurs the DPF may not operate as intended resulting in an increase of tailpipe emissions.
The engine turbocharger oil delivery pipe may not meet manufacturing specifications. As a result, engine oil could leak into the engine bay and accumulate in the presence of igniti…
Due to a programming issue, the fail-safe driving mode which helps reduce the effects of failure in the vehicle may activate unintentionally resulting in a loss of motive power.
The Diesel Particulate Filter (DPF) may crack due to overheating. If this occurs the DPF may not operate as intended resulting in an increase of tailpipe emissions.
Due to a manufacturing defect, the front drive shaft may become damaged and break. If this occurs, it could lead to a sudden loss of motive power.
The lower resin bumper cover may detach if damaged during vehicle operation.
Due to a manufacturing issue, the V-stay connection screws in the rear suspension may become loose causing the rear axle housing to move sideways. If this occurs, there is a risk o…
Due to a manufacturing defect the 12 Volt alternator wiring harness may come in contact with the transmission drive shaft. As a result, the wiring harness could become damaged caus…
Due to a software issue with the Engine Control Module (ECM), the vehicle may release air pollutants that exceed the standards set in Australian Design Rule (ADR) 80/03.
Due to a defect during assembly, the lock nut securing the steering draglink to the pitman arm may not have been tightened sufficiently and could become loose. If this occurs, the…
Due to a manufacturing issue, the headlamps may not be adjusted correctly. This could cause an incorrect headlamp range function of the vehicle.
Due to a manufacturing issue, the electric parking brake wiring harness may contact and chafe against the rear axle housing. If this occurs, it could lead to an unintentional parki…
The bolts connecting the variable camshaft timing unit to the engine may break. This may activate the limp home mode safety feature and potentially cause the engine warning light t…
Due to a manufacturing issue, the mounting screws on the left-hand side front bumper reinforcement bracket may not have been tightened sufficiently. As a result, the pedestrian de…
Due to a software issue, some vehicles may experience a thermal overload. If this occurs, vehicle occupants may identify smoke or fire emanating from underneath the vehicle.
Due to a software issue, the daytime running lights (DRL) will not provide the correct brightness.
The rear-view camera may not display the rear-view image whilst reversing as intended.
Due to a software issue, the Powertrain Control Module (PCM) may not activate as intended. As a result, the internal combustion engine will not start when required resulting in a r…
The internal components of the fuel pump may wear and fracture the welded area of the fuel pump, which could lead to a fuel leak in the engine compartment.If this was to occur, veh…
Due to a manufacturing issue, the CGW (Central Gate Way) control unit attached to the rear of the blower for the air conditioning in the passenger compartment may corrode due to mo…