Every safety recall published by the Australian government, searchable and filterable.
Some circuit boards may transmit compromised signals that cause inadvertent gearshifts to neutral on start-up.Note: Although vehicles in the US are sold with remote start, this op…
Some of these trailers may be equipped with Carlisle's Hydrastar or Hydrastar XL brake actuators, which are subject to wear at a higher than normal rate. As the component wears, th…
Insufficient water proofing of the sensor harness may allow moisture to penetrate the sensor resulting in abnormal output signal.
The passenger-side air bag inflator may have been assembled with improperly manufactured propellant.
An incorrect warning label has been attached to Hyundai i20 vehicle jacks.
The rear mufflers may not achieve the required service life and may crack.
The attachment points on the Nissan genuine accessory towbars can create excessive stress upon the chassis frame rails over time. As a result, cracks can occur at the ends of the r…
The fuel filter may develop a crack in the housing this could result in fuel leakage.
Due to a production fault on the upper part of the throttle grip housing, the throttle cable wire may slide out of the deflection roller and become wedged between the deflection ro…
Due to a production fault on the upper part of the throttle grip housing, the throttle cable wire may slide out of the deflection roller and become wedged between the deflection r…
High stress may cause a propogating fatigue crack and breakage of the right hand front driveshaft.
Adaptive Cruise Control (ACC) with Forward Collision Warning (FCW) components are not fitted to the affected vehicles.
In certain instances, the misrouting of the engine wiring harness may interfere with the intake manifold retaining bolt or tumble generator valve.
Due to production deviation the tightening torque may be too low on the front torque rods of the front axle with air suspension.
A certain number of our Dennis Eagle vehicles may have, during the course of having a modification carried out to improve steering geometry, not had the correct torque applied to t…
Cracks may develop in the lower inner panel of the rear car doors (around the B-pillar) where the front seat belt retractor is anchored. If the cracks occur in the panel, the sea…
It is possible that the fuel hose may detach from the fuel filter.
The indicator stems need to be replaced due to incorrect material composition causing the turn indicator stems to fracture after a short period of time.
A component inside the DC/DC converter (located under the front passenger seat) may be faulty.
The Vehicle Stability Assist (VSA) may not operate as designed and may cause Brake Assist functionality to operate spontaneously.
On all affected vehicles the cooling fan can continue to run even when the ignition is switched-off.
With a steering wheel adjusted into the lowest steering position, the top of the intermediate steering shaft may foul with the upper steering shaft knuckle.
Isuzu Motors Japan have identified that the Meritor Axle Lock Nut Locking Tab may have been misassembled and this may, in extreme cases, cause the wheel to come loose from the axle…
The bolt that secures the brake pipe bracket to the rear axle may not be manufactured to specifications and could loosen over time.
It is possible that the fuel return hose may detach.