Every safety recall published by the Australian government, searchable and filterable.
The driven gear in the wiper motor may fail due to incorrect grease application.
The bolted connection on the housing of the variable valve timing unit (VANOS) adjustment units may become loose. As a result the units may develop an internal oil leak and then no…
The bolted connection on the housing of the variable valve timing unit (VANOS) adjustment units may become loose. As a result the units may develop an internal oil leak and then no…
It cannot be ruled out that the piston rod of the rear spring strut, in connection with the Dynamic ESA option, could break.
Harley-Davidson Motor Company, lnc. has determined that some of these motorcycles may have been assembled with a front brake line in a position where it could become pinched betwee…
Load cycle shifts occurring when the vehicle is on the move causes pressure spikes in the engine oil at the shaft seal and these pressures can force the shaft seal out of its seat…
All Foton Tunland vehicles imported and distributed by Foton Automotive Australia, the previous distributor, have isofix identification labels fitted to the outboard rear seats whi…
Routine inspection of vehicles identified that the right hand rear brake pipe displayed evidence of a dynamic foul condition with the rear brake pipe touching a redundant bracket o…
Routine inspection of vehicles identified that the right hand rear brake pipe displayed evidence of a dynamic foul condition with the rear brake pipe touching a redundant bracket o…
After the Adaptive Cruise Control has been overriden, the vehicle may experience unintended and continued acceleration.
During routine production checks, KTM discovered that the tool for tightening the foot brake levers on the foot rest brackets was not set correctly.
The routing of the power supply cable, from the battery to the starter motor solenoid, may not conform to the design requirements.
A condition has been identified where the pretensioner wiring harness may make contact with a bolt at the base of the seat belt buckle assembly. As a result the wiring harness may…
Airbag module retention bolt could be incorrectly tensioned.
It is possible that when the rear door child safety locks are engaged (locked), if the interior door handle is operated, the door may still open.
Affected jacks do not comply with the requirements of the mandatory standard for vehicle jacks (based on the Australian/New Zealand Standard: AS/NZS 2693).
Suzuki has identified that the joint fastening between the lateral rod and the axle housing may become defective. The fastening bolt of the joint may become loose and the steering…
Due to a production error, the rivets fitted to affected seatbelt pre-tensioners were installed with excessive force. As a result, an affected rivet may become loose and pull-out a…
Suzuki has identified that the joint fastening between the lateral rod and the axle housing may become defective. The fastening bolt of the joint may become loose and the steering…
There is a defect with the engine crank case.
The front direction indicator lamp diagnostics do not provide the legally required double click/double flash warning required.
Failure during the welding process has potentially reduced the welding strength of the filler pipe. With continued use the subject welding portion could detach.
Due to a manufacturing error, in certain conditions internal circuits may be triggered, resulting in the vehicles keyless operating system shutting down. As a result the engine can…
Certain motorcycles may run out of fuel while the fuel guage indicator shows fuel remaining, and in some cases before the low fuel warning lamp illuminates.
The spring mechanism that locks the front seat track into the adjusted position may break. If this occurs, the seat may appear to be locked but not fully engaged.