Every safety recall published by the Australian government, searchable and filterable.
The right hand side spoiler on the rear-end door may not have been tightened according to specifications.
The welded connection of the rear seat bench may not have been correctly connected.
The Stop Light Switch may be affected by contaminants from outside the vehicle and could cause electrical contact points to malfunction.
Affected vehicles have been fitted with an oil pipe with a smaller interior pipe diameter than required. This may result in insufficient oil supply to the turbocharger’s turbine be…
Individual bolted connections on the front axle may not have been tightened to the specified torque.
An internal component within the clutch assembly may fail, preventing clutch disengagement which could result in the transmission failing to engage neutral when commanded by the dr…
Under certain conditions, the directional indicator lamps may fail to operate when the steering column mounted indicator controls are used. There will be no visual or audible warni…
Under certain conditions in cold climates, the tailgate lifting arms may freeze.
The Transmission Control Module (TCM) may incorrectly interpret an electrical signal from the gear selector lever and this has the potential to cause the automatic transmission to…
The CFK drive shaft contains a 3-hole-flange with pushing piece which is not produced with sufficient long-term durability. The pushing piece for the length compensation can be pul…
The ESP software may not meet the specifications. In certain scenarios the brake lights may be permanently activated and a warning message about the brake light malfunction would…
The electronically unlocking door locks may have been installed with an incorrect operating lever. As a result, the front driver's hinged door, the load compartment sliding door an…
In specific driving conditions the electric power steering control unit may display an error. This is due to a software fault which could result in a temporary loss of power assist…
The body mounting panels of the rear seat belt buckle anchorages used an incorrect grade of material. The rear seat belt anchorage performance may not fulfil the load requirements.
The outer cable sheath may have slipped through the end fitting causing the parking brake to become difficult to operate.
The affected vehicles may have a leak in the hose on the fuel line. The concern happens due to cracks appearing in the inner layer of the hose in combination with a pressurised sys…
Due to a software error, the electric power steering may become unavailable sporadically.If this occurs, greater force will then be required to turn the steering wheel. Power steer…
During refueling, if the fuel nozzle is turned or not inserted incorrectly into the filler tube, the liquid fuel can leak into the fuel tank system. Liquid fuel can be sucked into…
Increased electrical resistance in a component within the Electric Power Steering system may result in a loss of power steering assistance.
Due to improper routing, the rear brake hose and rear wheel rotation sensor lead may touch the rear tyre.
In certain vehicles, the speed sensor is manufactured using materials that have different thermal expansion properties. When the temperature increases, the materials inside the sen…
If a child seat is installed in the front passenger seat, it is possible that the front passenger airbag might not be switched off as intended and could be triggered in the event o…
In some vehicles, the locking mechanism on the rear sliding door may be defective and unable to hold the door open.When the vehicle is at a forward incline, the holding mechanism m…
In certain vehicles, the Owner's Manual supplied may not contain all relevant information required by the mandatory standard. In other vehicles, the Owner's Manual may not have bee…
The outer section of the front grille air deflectors could detach partially or entirely from the inner section of vehicle. Clips could slowly detach due to the wind loads that aris…