Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing defect, excessive heat from the exhaust may soften the paint around the gear change pivot bolt. If this occurs, the bolt may become loose and the gear shift…
Due to a software issue with the Powertrain Control Module (PCM), the signal from the crankshaft position sensor may fail. As a result, the vehicle may experience a loss of motive…
Due to a manufacturing issue, the wiring harness between the door pressure sensor and the airbag control unit has an incorrect connector pin allocation.
The seat brackets in the rear cabin do not comply with Australian Design Rule (ADR 03/04) - Seats and Seat Anchorages requirements and may fail.
Due to a software issue, the Instrument Panel Cluster (IPC) may fail to illuminate the visual and audible warnings for seat belt, vehicle speed, fuel level, engine status and other…
Incorrect fuel consumption and emission data has been provided on the fuel consumption label.
Due to a manufacturing defect, the fuel pipe may chafe against the support bracket and become damaged. If this occurs fuel may leak, potentially resulting in loss of motive power w…
Due to a manufacturing issue, the fitting connecting the delivery hoses to the lift axle spring brake may not have been tightened to the sufficient torque and could become loose. T…
Due to a software issue with the Electronic Management System (EMS), the vehicle may release air pollutants that exceed the standards set in Australian Design Rule.
Due to a software issue with the Electronic Management System (EMS), the vehicle may release air pollutants that exceed the standards set in Australian Design Rule.
Due to a manufacturing issue, the rear-view camera may not display the rear-view image whilst reversing as intended.
Due to a manufacturing defect, inadequate sealing of the starter motor may allow moisture to enter into the unit. If this occurs, corrosion may result in the engine not starting.In…
Due to a manufacturing issue, under certain driving conditions the upper triple clamp that secures the handlebar may fracture. This could lead to a loss of vehicle control whilst r…
Due to a manufacturing defect, the front passenger and/or driver seatbelts may not meet the required specifications. As a result, the seatbelt(s) may not operate as intended in the…
Due to a manufacturing defect, the fuel pipe may become damaged over time, caused by vibration and extended high RPM usage. If this occurs, fuel may leak potentially causing a loss…
Due to a supplier manufacturing defect, the high-pressure fuel pump may not have been fastened to the cylinder head with sufficient torque. As a result, fuel may leak, and in the p…
Due to a software issue, the electromechanical brake servo control unit may switch off. As a result, the braking assistance could be reduced, requiring greater pedal force and pote…
Due to a manufacturing defect, the Body Control Module (BCM) may be susceptible to water ingress. As a result, the front and rear side marker lamps, taillamps, and license plate la…
Due to a software issue, when the vehicle starts the Instrument Panel Cluster (IPC) may fail to illuminate visual critical safety information upon start-up.
Due to a manufacturing defect, the rear wheel hub bolts may become loose or break causing damage to the wheel axle and axle hub splines over time. This could result in the vehicle…
Due to a software issue, the vehicle may accelerate without the pedal being depressed. This may result in unintended vehicle movement.
Due to a software programming issue of the Body Control Module (BCM), the instrument cluster fuel level may not operate as intended. This may result in an incorrect display of fuel…
Due to the programming of the Heating, Ventilation, and Air Conditioning (HVAC) control ECU software. Under certain conditions, such as a specific failure mode of the electric comp…
The rear wheel shaft could lose its structural integrity and, in extreme cases, break whilst riding.
Due to a software issue, the brake boost function may not operate as intended. As a result, braking could be reduced requiring greater pedal force and potentially increasing the ve…