Every safety recall published by the Australian government, searchable and filterable.
The seat(s) on the specified models may have been manufactured with a seat fastener that was not tightened to the proper torque specification.
The front windscreen wiper motor bottom cover may melt.
The front passenger airbag inflator contains compressed gas and propellant to inflate the airbag. There is a possibility that during the manufacturing process, some inflators may h…
The transaxle wiring harness may have been built with insufficient wire terminal crimp(s), causing an intermittent high electrical resistance in the transaxle wire harness circuit(…
The high pressure fuel line may not have been manufactured to specification, this could result in fuel leakage.
The high pressure fuel line may not have been manufactured to specification.
Under bonnet fuel hoses routed on top of the engine may chafe against a plastic moulded noise suppressing material retaining posts of the underside of the engine top cover. The Noi…
The injectors’ fuel supply rail may pose a leak risk in the long-term.
The electronic shift lever in the vehicle does not move like a conventional shifter and the driver may inadvertently fail to correctly engage the “PARK” position before exiting the…
The electronic shift lever in the vehicle does not move like a conventional shifter and the driver may inadvertently fail to correctly engage the “PARK” position before exiting the…
The hydraulic clutch system with black master cylinder on certain MY 2016 Touring and Softail motorcycles may exhibit a condition in which it may lose the ability to generate enou…
On the affected vehicles, the welding between the fuel tank and rollover valve (ROV) may peel off, causing a fuel leak.
A pivot pin inside the twin buckle assembly for the right-hand rear and rear centre seatbelts may not have been assembled correctly and may translate sideways.
Due to incorrect Quality Control during the manufacturing process, the engine crankshaft bearings may fail and cause the engine to stop suddenly and be unable to be restarted.
A joint on the drive shaft may come loose resulting in a loss of drive.
The driver airbag performance is outside of the required specification for time to inflate due to a malformed canister. In this condition, the flow of the gas generated for airbag…
The recliner mechanisms fitted to the 2nd row (60% side, with left and centre seats) may not lock correctly when the seat back is placed into the upright position.
The fuel suction plate located within the fuel tank may develop a crack which could expand over time. In this condition, fuel may eventually leak when the vehicle has a full tank…
The clock spring on certain vehicles may ingest dust if the vehicle is subjected to extremely dusty environments.
The clock spring on certain vehicles may ingest dust if the vehicle is subjected to dusty environments.
Unburned fuel can be routed in to the exhaust system, which can cause elevated exhaust temperatures.
In certain vehicles, under bonnet fuel hoses have been misrouted. The metal hose clip fitted to the under bonnet fuel hoses, in the mis-routed condition, can chafe a nylon fuel pip…
In the event of an accident the front left side airbag may not deploy correctly because of an incorrectly folded airbag.
There is a risk of the passenger airbag mounting screws being absent.
In the event of airbag deployment during an accident the fabric of the side airbag may tear.