Every safety recall published by the Australian government, searchable and filterable.
These vehicles use software to control the hybrid system. The software is designed to put the system into a fail-safe mode if there is an internal component failure. This allows th…
The front brake pad friction material could potentially separate from the back plate, resulting in reduced braking performance.
The weld seams' strength on the rear bumper cross member might not meet the required specification.
The front seat belt buckle housings may not have been correctly manufactured.A correctly-fastened seat belt could be detected as not fastened. If this occurs, a seat belt warning l…
A crack developing in the steering lock housing can cause the steering wheel to lock into the straight ahead position when the key is turned.
The lock symbol embossed on the operating lever for the child safety lock may show the locking status incorrectly.
The steering track rods may be damaged when exposed to high temperatures and vibrational loads. If the steering track rods are damaged or break, the vehicle will have limited steer…
The second row, right side seat belt shoulder anchorage was incorrectly assembled and may not restrain the occupant properly.
Due to an improper manufacturing process, a component within the fuel pump could swell causing the fuel pump to become inoperative.
The brake hoses may contact the rear part of the fender liner of the front axle while driving the vehicle, causing anything from chafe marks to worn out brake hoses, resulting in l…
Moisture may enter via a gap in the housing of the starter-alternator, potentially causing the component to overheat.
The wiring harness for the right seat of the second seat row may be damaged if the seat is moved along the guide rail.For vehicles equipped with rear side airbags, the side airbag…
Due to the weakness of a component in the 'quick connector' on the fuel supply line, fuel may leak at very high engine compartment temperatures.
Due to a production issue with the transmission oil pipe at the supplier's production line, the integrity of the welded joint may be compromised and cause a transmission fluid leak…
Due to the weakness of a component in the 'quick connector' on the fuel supply line, fuel may leak at very high engine compartment temperatures.
A gearbox oil pipe may have been incorrectly welded, which can result in a transmission oil leakage.
Small cracks may form in the front lower suspension arms and with rapid acceleration and deceleration over the parts' lifetime, these cracks could spread and the suspension arm can…
The Engine Control Unit (ECU) programming may cause the engine to after fire when the Kawasaki Quick Shifter (KQS) function is used under heavy engine load (high rpm and throttle o…
The transmission fluid pump gears could fail while driving.
The transmission fluid pump gears could fail while driving.
A gearbox oil pipe may have been incorrectly welded which can result in a transmission oil leakage.
The roof spoiler can partially or completely detach from the vehicle, due to the use of an unsuitable adhesive.
Due to an improper manufacturing process, the front brake pad material may separate from the brake pad.
A manufacturing defect may cause the windshield wiper arm head joint to strip.
The noise vibration and harshness (NVH) foam pad positioned underneath the fuel tank can potentially trap corrosive moisture, which can over time cause corrosion of the surface of…