Every safety recall published by the Australian government, searchable and filterable.
The braking system’s power assistance may be lost or reduced. This is due to a reduction of available vacuum in the system due to degradation of the timing belt if affected by aged…
The braking system’s power assistance may be lost or reduced. This is due to a reduction of available vacuum in the system due to degradation of the timing belt if affected by aged…
The electronic brake booster (EBB) may be incorrectly set up, and may not operate correctly.
Due to a manufacturing fault, the vehicle's rear driveshaft bearing support bracket may hold the driveshaft at the incorrect angle, causing excessive wear to the driveshaft over ti…
A faulty brake switch can inhibit the cruise control and constantly illuminate the rear brake lights.
The stop lamp relay may stick in the ON position.
Due to a manufacturing defect, the rear brake pipe may leak brake fluid.
The rear section of the wiring harness may have been routed incorrectly during assembly. This may have damaged the wiring harness.
The cable for the spare wheel winch can be weakened and snap when used under certain conditions (extreme dirt/dust exposure). The spare wheel will then only be secured by the secon…
Bolts may not have been installed on the longitudinal adjustment mechanism of the driver seat.
The baggage and sleeper doors may separate from the vehicle door hinge.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a coll…
The SRS control unit may not be tightened to the vehicle's body correctly. If this occurs, the airbag system light will illuminate and an error message will appear on the instrumen…
The second gear may fail due to excessive stress loading during shifting and missed second gear selection, resulting in loss of power.
The front bumper may not comply with Australian Design Rule (ADR) 92/00, it may not have a bumper closeout and tow hook cover.
The dual chamber compressed air storage tank(s) may unexpectedly rupture due to metal fatigue.
Due to a manufacturing defect, the rear brake pipe may leak brake fluid.
The steering knuckle bolts may not be sufficiently tightened, which can cause the steering knuckle, hub and the bearing assemblies to become detached. If the front knuckle bolts gr…
The front brake master cylinder may have components missing, which may interfere with the force applied when braking. This can result in a loss of brake performance.
A narrow clearance between the fuel pipe on the engine and the frame may result in the fuel pipe contacting the frame.If the operator continues to use the vehicle with the frame in…
Due to a manufacturing fault, the strength of the camshaft chain tensioner may be insufficient. This may cause the engine to generate abnormal noises, and in some cases the engine…
A connector may become detached from the crash sensor, which may delay the operation of the side airbag, curtain airbag and/or belt tensioner.
The fuel pump relay on some vehicles may be susceptible to silicon contamination on the relay contacts. This can cause the relay to fail.This fuel pump relay was installed as part…
Fuel leakage may develop at the fuel cock. Incorrect press fitting procedure during assembly may have damaged the fuel cock tube which may result in fuel leakage.
Due to a manufacturing error, an electronic control circuit board in the Anti-Lock Braking System (ABS) module will short circuit when the components are exposed to moisture.