Every safety recall published by the Australian government, searchable and filterable.
The engines contain valve springs that could have been produced with corrosive pitting on the surface of the spring. The corrosive pitting could lead to fatigue cracks, which could…
An incorrect specification stop lamp switch was installed in some Nissan C12 Pulsar vehicles fitted with CVT automatic transmission. In extremely rare cases, the rear stop lamps ma…
The rear seat centre child restraint anchor point is not accessible due to an incorrect seat backrest trim fitted during production.
It has been found on a very small number of vehicles that the driver's seatbelt stalk mounting eyelet flange may have been crimped onto the seatbelt stalk cable at the wrong angle.
It is possible that the throttle pedal lever may fracture.
Suzuki Motor Corporation have advised that corrosion may start between the brake piston and return spring (located inside the piston). Moisture may be absorbed by the brake fluid…
Audi A8 vehicles with glass sliding/tilting sunroof (PR number 3FE) manufactured within a specific period, an unfavourable stress distribution was set up in the glass roof panel du…
On vehicles fitted with carbon ceramic brake discs, the stainless steel screws fixing the rotor to the metal bell may fail due to corrosion if the vehicle has been used in salty en…
On the rear axle of vehicles fitted with carbon ceramic brakes (CSiC), the stainless steel screws fixing the brake rotor to the metal bell may fail due to corrosion if the vehicle…
On vehicles fitted with carbon ceramic brake discs, the stainless steel screws fixing the rotor to the metal bell may fail due to corrosion if the vehicle has been used in salty en…
Holden has identified a condition where, in some instances, the right-hand tubular driveshaft may fracture.
Vibration on long rides at a constant high engine rpm, under certain circumstances can cause foaming of the brake fluid in the brake reservoir.
Vibration on long rides at a constant high engine rpm, under certain circumstances, can cause foaming of the brake fluid in the brake reservoir.
On vehicles manufactured prior to 27th March 2011, the adhesive primer may have not been applied during installation of the panorama glass roof. In the worst case scenario, the ro…
The programmed setting on the ECU (Electronic Control Unit) is incorrect.
Over time the side stand could work loose, causing it to become unattached from the motorcycle. Additionally, the side stand switch may not work reliably and the engine will not sh…
A condition has been identified where, in some instances, an incorrect diaphragm spring was installed within the LPG vaporiser that may comprimise the diaphragm. When the diaphragm…
The brake vacuum hose may have been supplied without an internal check valve. When the engine is not running, this may lead to a loss of brake vacuum assistance.
The intermediate steering shaft might have been fitted incorrectly in some vehicles.
It is possible that the park brake lever lock nut has not been correctly tensioned. This may result in damage to the park brake cable.
Due to electrolysis, the DSG transmissions are susceptible to conductive deposits forming in the gearbox control units, possibly causing the gearbox fuse to blow. Should this happ…
Due to electrolysis, the DSG 7-speed transmissions are susceptible to conductive deposits forming in the gearbox control units, possibly causing the gearbox fuse to blow. Should th…
Due to electrolysis, the DSG 7-speed transmissions are susceptible to conductive deposits forming in the gearbox control units, possibly causing the gearbox fuse to blow. Should th…
Maserati is recalling Quattroporte & Granturismo vehicles to replace both rear tie-rods for toe-in adjustment because they may have been coated with an uneven thickness of paint, p…
Due to electrolysis, the DSG 7-speed transmissions are susceptible to conductive deposits forming in the gearbox control units, possibly causing the gearbox fuse to blow. Should th…