Every safety recall published by the Australian government, searchable and filterable.
A possible safety related condition may exist in the rear brake shoe assemblies fitted to the affected models. The rear brake shoe friction material may separate from the shoe, re…
The throttle cable seal may deteriorate over time, and stick to the inner cable. If the seal sticks to the inner cable, it is possible that the engine speed may not reduce when th…
BSI Software Download. This action is necessary to eliminate the possible inadvertent continuous activation of the horn after pressing the high frequency button on the vehicles re…
The AVCS Oil Flow control Valve. The potential safety issue is related to the possibility of an oil leak due to insufficient tightening of bolts that secure the valve cover plates…
This vehicle had a speed restriction label on the space saver spare wheel replaced due to poor adhesion of the label to the wheel.
Software Download for Engine ECU. This action is necessary to eliminate oscillation of the motorized throttle valve which, in extremely rare cases, may cause breakage of the throt…
Download Engine ECU Software. This action is necessary to eliminate oscillation of the motorized throttle valve which, in extremely rare cases, may cause breakage of the throttle…
During the pressing process variations in material properties may have contributed to the formation of splits on both ends of the rear lower suspension arm. Mitsubishi advise that…
A rear suspension unit on the affected model may have been incorrectly manufactured. The Company will replace both rear suspension units on all models affected.
In the brake master cylinder there is a possibility that the recess that retains the rubber seal ring, located at the end of the cylinder body, may be corroded due to an improper w…
Under high ambient conditions with the blower operating at maximum setting for longer periods, it is possible for the blower fuse to reach higher than anticipated temperatures.
The Turbo Return Pipe. There have been instances of the pressurised oil pipe to the turbocharger chafing against the flange on the exhaust manifold on D9 engines.
Under certain operating conditions some electric cooling fans may overheat potentially causing heat damage and, in rare instances, a fire in the engine compartment.
Under certain operating conditions some electric cooling fans may overheat potentially causing heat damage and, in rare instances, a fire in the engine compartment.
Under certain operating conditions some electric cooling fans may overheat potentially causing heat damage and, in rare instances, a fire in the engine compartment.
Single sensing seatbelts (vehicle decceleration only) fitted to the retractor seatbelts. The ADR requires webbing acceleration (W) sensing also.
A protective cap must be installed over two valve cover studs and the affected wiring harnesses must be rerouted.
It is possible a leak could develop from a hydraulic line of the Active Body Control (ABC) system between the pressure supply valve and the front/rear axle distributor unit.
The wiper switch if operated frequently on intermittent may cause the contact points to detach causing a short circuit.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
All affected Touareg vehicles of the above chassis number range, faulty rear belt locks may have been fitted because of a riveting defect. Volkswagen will also take the opportunit…