Every safety recall published by the Australian government, searchable and filterable.
Check Side Airbag Wiring. Correction of pin allocation for front right and front left head/thorax airbag.
The recall relates to a Trailer with Electronic Braking System (EBS) when connected the trailer warning light will not be activated. However, the braking functionality is not affe…
A possible defect exists due to the possibility that the trunk harness may become damaged, causing an open circuit and either resulting in the loss of the license plate lamp, rever…
Affected vehicles will be recalled to inspect that the rear subframe fixing is correctly fitted and clamped up.
The intermittent relay contact points located in the wiper combination switch assembly due to a durability factor may wear prematurely. Frequent operation of the intermittent wipe…
Under certain circumstances the fuel tank weld joint for the vent rigs could crack; this could possibly be related to fuel quality or environmental conditions.
It is possible that a small percentage of the tyres may experience belt detachment, especially if operated below recommended inflation pressures for the load carried by the tyre or…
The rear fuel line has the potential to chafe against the ABS/water sensor harness and fuel pump harness. Prolonged chafing could result in a fuel leak from the main fuel feed lin…
Safety recall to check and, if necessary, replace the front suspension pivot(s) and pivot ball joint(s). This action is necessary to eliminate the risk of a vehicle trajectory out…
The engine was assembled with incorrect air cleaner cap and engine control computers. As a result the vehicle does not match the specification covered by its approval to ECE Regul…
The front brake hose(s) could become trapped between the front fork and the front fender. This allows the front fork cover to contact the brake hose causing abrasion damage as the…
On eligible units, spokes of the front wheel may contain casting flaws that affect the strength of the front wheel. Continued use of a front wheel containing casting flaws may pot…
There is a possibility that the right hand rear wheel brake pipe may come into contact with a wiring harness bracket. As a result, the brake pipe may wear leading to brake fluid l…
Rear brake master cylinder connecting rod end bearing corrosion, on the affected units. Due to improper material selection for the rear brake master cylinder connecting rod small…
In the automatic transmission a small metal tang on the 'brake No 4 tube' may snap off. This piece could stop the engagement of the locking pawl for the P position.
The fuel distribution rail may crack resulting in a fuel leak. This may cause a fire in the engine compartment. As a precaution, the fuel distribution rail and connecting fuel ho…
The engine hood safety lock bracket profile may not be formed to specification. As a result, the safety lock may not function correctly. In the worst case, if the vehicle is drive…
Under severe conditions the transmission may overheat. If it overheats lubrication may be inadequate and a gear could fracture.
One of the steel airlines under the cab floor may rub through with contact on the intercooler hose and clamp. If the airline leaks the system will be drained and the spring brakes…
Clearance between the engine hood and the cowl louvre may allow water to enter the engine compartment under certain conditions, ie. heavy rain or frequent car washing. In some cas…
Update Software in CDI Engine Control Unit. It is possible that the engine may run rough or cut out unexpectedly.
The possibility exists for the male fuel line connectors (which connect the fuel feed and return hoses to the fuel pump mounting plate) to fracture, thereby possibly causing fuel t…
The wheel hub bores in the wheel rim may be too small. As a consequence, the wheel may not make proper contact with the brake disc, although the wheel bolts may have been tightene…
Seatbelt retractors don't comply with ADR4/03. May not satisfactorily operate in the event of a collision.
The two non-protected passenger seats, namely the seat immediately behind the bus side access door and the inboard (aisle) seat behind the driver's seating position have not been f…