Every safety recall published by the Australian government, searchable and filterable.
Normal front suspension travel could allow the rear tip of the front fender to become locked in the Voltage Regulator Cover installed as an accessory item - thus severely limiting…
There is a possibility that the tyre bead may have been damaged during the process of mounting the tyre onto the wheel. This damage may lead to loss of tyre air pressure.
Defective spot welds may potentially affect occupant protection in the event of a side impact collision.
A potential exists for the throttle to bind.
Four 8.8 bolts that retain the bracket for the intermediate droparm can lose clamping force, which can cause bolts to shear off causing loss of steering.
Possibility for drag link ball joint of the steering system to crack and break. Can cause loss of steering.
The fitment of the ASCD accessory has been found to be subject to a number of fitment quality issues, the most severe of which may result in the vehicle throttle cable becoming stu…
ECU software download is necessary to eliminate oscillation of the motorized throttle valve which, in extremely rare cases, may cause breakage of the throttle stop. As a result, t…
Location of steering rack may be incorrect on some vehicles causing misalignment between steering rack and intermediate gear. Continuous use in this condition may damage the unive…
An assembly error in production may result in pinching of the charcoal canister (fuel vapour storage canister) vent hose. In this condition, high vacuum in the fuel tank may cause…
Silicon oxide may be generated on the surface of the contact point. Oxidisation may cause a resistence in the circuit causing stop lamp to become inoperative.
Emissions plates with wrong smoke data have been attached to rocker covers engines DC16 03.
On some eligible units a wrong O-ring was installed on the shock absorber.
There is a possibility the upper power steering return hose may split and leak hydraulic fluid in the engine compartment.
Instances have occurred where a truck's power supply has been shut down due to the roll-over sensor tripping in other than roll-over situations. Should the Battery Isolation switc…
The exhaust clamp used to secure the middle muffler to the front exhaust pipe may loosen during operation and allow the muffler to separate from the front pipe.
The brake booster intensifier may have an incorrectly machined groove on the hydraulic piston, where the piston cup is located. The incorrect machining may cause insufficient seal…
When braking using the retarder in vehicles equipped with EDC and Scania retarder but without ABS, it is possible to disengage the retarder by activating the accelerator pedal. Th…
The firewall silencer mat may retain moisture that then causes corrosion where it is in contact with the fuel pipe. In worst case due to the corrosion the fuel pipe may become per…
Cases have been reported of the intermediate droparm's nut coming loose due to the tab that secures the lock washer in the shaft breaking. The result is slack in the buses steerin…
Some 2002 affected vehicles are fitted with a ball stud bracket located on the rear liftgate window which could rotate out of position on the glass. Additionally, all affected vehi…
When the vehicle is parked on an incline, with the handbrake on and the vehicle out of gear, there is the possibility that the vehicle could roll away sometime later.
The front seatbelts may not latch correctly.
The front seatbelts may not latch correctly.
The affected vehicles have been fitted with an unrestricted fuel filler neck and will be recalled to have a restricted fuel filler neck fitted.