Every safety recall published by the Australian government, searchable and filterable.
During the manufacture of two fuel pipes located on the engine's fuel delivery manifold, high stress areas may have been created in the pipes. Combined with other factors such as c…
The front edge of the older design genuine accessory carpet mat overlaps the arc of travel of the accelerator pedal. This creates the potential for interference of the carpet mat w…
The spare wheel in the FDi30 SX and SLX variants are fitted from factory with a steel wheel and 185/65 R15 tyre. The road wheels on the SX variant are 195/65R15 steel wheels and th…
A limited number of trucks have an incorrectly welded fluid coupling.
A potential problem exists with restricted lateral movement of the sliding carriage of the fitted top rack, which could lead to reduced stability of the motorcycle if ridden at spe…
A number of NS Pajero vehicles have been manufactured with the incorrect nuts used to retain the front R/H drive shaft and both front and rear propeller shafts. The threaded portio…
A potential fault in the glow plug relay, which is part of the engine pre-heating system, may cause the coil to overheat and possibly short circuit.
Clutch and front and rear brake shoes may contain asbestos.
In certain circumstances the underhood speed control deactivation switch mounted on the brake master cylinder may leak and brake fluid contamination in the electrical connector may…
On affected models, during use the 1/4 turn filler cap may leak from the sealing area of the filler cap and fuel tank.
The existing labelling of the Jack does not fully comply with the requirements of the mandatory consumer product safety standard for vehicle jacks based on Australian/New Zealand S…
The air pressure warning light (equipped with as Visible Indicator regulated in ADR 35/01 S.5.2') was not so designed that, as a check of function, it operates when the ignition ke…
There is a possibility that an incorrect tightening of the muffler mounting bolts may cause the bolts to unscrew by vibration, which may result in the muffler falling off and creat…
In isolated instances, fuel lines suffered incipient damage in the course of the manufacturing process. Lines damaged in this way could develop leaks soon after customers start usi…
Some G650 Xchallenge motorcycles left the factory with the wrong circlip installed on the left-hand side of the rear wheel-bearing guide. The result can be that this circlip rubs a…
The affected LPG tanks may have a service valve hand tap that could fail causing LPG to leak from the hand tap spindle.
The incorrect Compliance Plate Approval (CPA) number was embossed on the compliance plate.
Certain Douglas Autotech steering columns may have been manufactured without two welds which could cause the column to fatigue and fracture over time, thereby allowing the steering…
Investigations by the manufacturer have shown that there is a possibility the thread profile for the rear axle hub retaining nut may be out of specification, thereby decreasing the…
Some vehicles may experience heater tap coolant leaks. These leaks can ingress into electrical connectors via the wiring harness.
A small number of seat riser boxes were supplied by Isringhausen which do not fully comply with ADR requirements for structural strength. Should a vehicle with a faulty seat riser…
There is a possibility that the fuel pump may wear prematurely due to insufficient clearance between the coils of the internal motor. If vehicle operation continues in this conditi…
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
Due to the shape of the gearshift select lever cable retainer clip, there is a possibility that the clip may impact the gearshift select lever bracket if excessive lateral force is…