Every safety recall published by the Australian government, searchable and filterable.
Due to insufficient strength of the key-way in the clutch fork, the clutch fork may crack during normal operational use. If the truck continues to be used in this condition the clu…
There is a possibility that the latches securing the saddlebags to the vehicle may break if large force is applied. Continued use of the vehicle with the saddlebag latch broken cou…
There is a possibility that the rear carrier may break if a mounted luggage system is installed. This could result in the luggage carrier becoming detached from the vehicle creatin…
Some trailers require additional gussets on the rear cross member.
There is a potential for the mounting bracket of the chrome exhaust extension to fracture. In the worst case condition the exhaust extension may become detached from the vehicle ca…
Certain vehicles may have been manufactured during the above production range with centre rear suspension brackets cast out of square which could lead to the development of cracks…
In vehicles with rear air conditioning, the lens of the interior light located in the air duct may deform during continuous operation due to an elevated temperature resulting from…
In certain TAS85 steering gears an incorrect profile on the sector shaft gear may lead to chipping and damage of the gear. These chips can cause the steering to bind or stick durin…
One of the fuel lines in the engine compartment may have a rub condition with a fuel vapor hose clip.
Investigations have shown that the front brake callipers on the vehicles may have been incorrectly manufactured and could break under certain operating conditions. This could poten…
Investigations have shown engine coolant may be drawn into the left radiator cooling fan motor connector in the vehicles. This could potentially cause an electrical short circuit.
Investigations have shown that the front door latch cables may become unseated from the interior release handle housing under certain conditions. This could cause the door latch ha…
In some circumstances ingress of water into the carburettor throttle body may occur due to rain or pressure washing. The water may freeze and cause the throttle to have sluggish re…
Cracks may develop in the steering idler arm after an extended period of operation. In an extreme case, a cracked steering idler arm may break without warning and cause a loss of s…
Die to fatigue a crack may develop in the brazed portion of the air vent pipe in the bottom of the fuel tank, resulting in fuel leakage.
Due to the deterioration with age of the tubeless valves fitted to the front and rear wheels, the rubber may lose its sealing ability, resulting in the gradual or rapid loss of tyr…
It is necessary to check that the anchoring of pipes is performed by using the specific clips on the bodywork.
The climate control system may have limited operation after engine start up. In these instances there may be no defroster operation.
Failure of the number plate holder support.
The engine installed in affected vehicles may be fitted with a front end accessory drive belt that could delaminate and result in premature failure.
If the independent trailer handpiece is actuated while the vehicle is in cruise control, the cruise control will not cutout and the engine will continue driving. After the trailer…
Potential fluid loss from a power steering feed hose. The cause of the power steering hose fluid loss is unexpectedly high heat deterioration, causing a corresponding loss of mater…
Engine stalls at idle, which could endanger rider safety. Problem to be fixed by downloading new software to the engine control unit.
Depending on the axle and suspension type, specific vans that have been manufactured by Jayco Corporation Pty Ltd may require a change to the jacking point of the van.
Investigations have shown that the EBC module may have been programmed with an incorrect software version. It is possible under certain conditions that a momentary delay in braking…