Every safety recall published by the Australian government, searchable and filterable.
It is possible for the rear brake calliper hose to come into contact with the rear suspension spring which, over time, could wear the hose.
A rectifier diode used in the DC-DC converter may have been damaged during manufacture which could lead to an internal short circuit during customer usage.
The valve on the vacuum pump in the brake assistance circuit may have a manufacturing non-conformity.
Some regulator/rectifier assemblies were produced with insufficient adhesion between the power module and the rectifier case. Due to the insufficient adhesion, heat generated from…
The front door wiring harness on your vehicle may fatigue and break. Broken wires could interrupt circuts for the side impact sensor(s), resulting in the illumination of the airba…
There should have been a glass splash back fixed to the kitchen wall to protect the wall from heat generated by the cooker.
The sliding portion between the lost motion spring and rocker arm is not sufficiently lubricated for high surface pressure setting at low engine speed, potentially causing breakage…
The internal dimension of the press fit collars may be oversized, reducing the locking capacity of the collar.
The engine drive belt tension adjuster pulley, which maintains tension of the engine drive belt for various ancillaries, has been found to potentially have an incorrectly manufactu…
On vehicles fitted with these kits, the Body Control Module (BCM) has a case that may not be sealed sufficiently to prevent water intrusion. Water intrusion of the BCM may lead to…
A bonding condition may exist with the glass panel on the sunroof.
A bonding condition may exist with the glass panel on the sunroof.
The cruise control system may not operate correctly.
Due to insufficient tightening of the fuel pressure sensor connected to the engine fuel delivery pipe with Nickel Phosphorus plating, there is a possibility that, over time, the pr…
The braking assistance circuit vacuum pump valve in very rare cases may have problems opening.
In certain conditions (downshifting or manoeuvring with the clutch disengaged with the engine at idle) it is possible that the engine may stall.
The front wiper blade motors have an internal non-conformity.
Some of these models may have been shipped with an incorrect Australian ADR 83/00 Stationary Noise label part number.
There is insufficient margin set for the length of an electric wire connected to the headlight switch. As a result, the terminal joint portion moves, contact resistance increases,…
The eye bolt securing the oil pipe to the vacuum pump was not tightened to the correct torque during production.
The engine oil level may be above the maximum level marking. If the engine oil level is above maximum it may lead to increased engine speed.
Due to a change in design of the carpet floor mat between 10MY and 11MY vehicles, it is possible that the incorrect mats may have been fitted to the PB model challenger vehicles at…
The front fender liners on the vehicle may detach or sag allowing the fender liner to contact one or more of the brake tubes.
There have been instances where the bellows brackets have fractured. The bellows brackets fracture at the upper torque rod attachment. This is because the suspension brackets side…
In the event of emergency braking or vehicle collision, the rear seat assembly may not remain in the locked position and may move forward with the motion of the vehicle.