Every safety recall published by the Australian government, searchable and filterable.
Some brake booster pumps may be manufactured improperly, and may cause the brake assist function to stop operating while driving.
Brake caliper mounting bolts may not provide adequate clamping force between the brake caliper and brake anchor plate.
The wire harness for the electric power steering may be damaged, resulting in the insulation on the wire harness becoming damaged over the service life of the vehicle.
The vehicle's sun visor does not have the required labelling advising consumers not to install rearward-facing child restraints in the front seat of the vehicle, and the owner's ma…
The metal bracket on the vehicle under cover may separate from the vehicle while driving.
The throttle control cable may break.
The plastic sleeve of the selector lever cable may not be durable throughout the service life of the vehicle. If the plastic sleeve breaks, the transmission may not change into par…
In some instances, there is a risk that one or several fixing nuts may be missing from the individual rear passenger seat.
The seat belt may jam in the seat belt guide loop, causing the seat belt to loosen and not retract upon movement.
In some instances, the front driver air bag may not inflate to its fullest capacity fast enough when required.
The brake pedal linkage clip may have been manufactured incorrectly. A defective or missing brake pedal linkage clip could cause the brake booster input rod to detach from the bra…
The front track bar mounting bolt may not have been tightened to specification. A loose mounting bolt may cause a rattle or banging noise under certain driving conditions.
The length of the rear wheel hub mounting bolts may prevent use of the park brake.
Due to the improper materials used in the production of the brake light switch, the switch may corrode if exposed to water.
Caliper mounting bolts may not provide adequate clamping force between the brake caliper and brake anchor plate.
During a limited production period for Volkswagen Tiguan Allspace vehicles, a certain material used in the production of the rear springs was not approved for use in the process. A…
On affected vehicles the drive axle may break due to a nonconformity in the production process.
Due to a processing error, the locking pin securing the head restraint may be missing on individual head restraints for the rear centre seat.
If the regenerative brakes fail, the friction braking system may not perform as quickly as required.
Self-adjusting function in the brake caliper housing out of function. As a consequence, reduced or lost brake function on park and service system is experienced.
Lock nuts with possible production deviations may have been installed in the steering system of certain vehicles.
Lock nuts with possible production deviations may have been installed in the steering system of certain vehicles.
Self-adjusting function in the brake caliper housing out of function, resulting in reduced braking performance when applying the parking brake or when using the service brake.
A sensor for the electric power steering on the vehicle may have been manufactured outside of the specification.
Self-adjusting function in the brake caliper housing out of function, resulting in reduced braking performance when applying the parking brake or when using the service brake.