Every safety recall published by the Australian government, searchable and filterable.
Some motorcycles equipped with halogen headlights may have been assembled using a non-compliant headlight not matching Australian Design Rules (ADR) requirements.
On affected vehicles, the striker wire support on the bonnet lining may not be sufficiently secure. This may allow the bonnet to open while the vehicle is in motion.
The gearshift cable retaining clip may not be securely fastened, which could lead to the gearshift cables making contact with the rear driveshaft.
The gearshift cable retaining clip may not be fully engaged, which could lead to the gearshift cables moving out of position and contacting the propeller shaft.
There is a possibility that an engine oil-way blanking plug may become dislodged.
The driver is not alerted to low air pressure in the braking system because the air system warning is set too low.
The front brake mounting hardware may have been under torqued and the incorrect torque tool used during manufacture.
On some heavy-duty trucks with rear tandem-axle and leaf suspensions, the shape of the radius rod brackets mounted to the trunnion cross member is incorrect. The input from the rad…
The Exhaust Gas Recirculation (EGR) pipe may break due to a potential non-conformity.
On affected vehicles the screw/bolt in the range group catch bolts may come loose.
A weld seam has been improperly applied to out-of-line axle housings during the production process.
The affected Power Relay/s may generate excessive heat, resulting in relay failure. As a result, the engine may stall during driving, fail to restart or failsafe protection may be…
The engine of affected vehicles may turn off when braking at a low speed (e.g. when braking for a traffic light).Also, after an ECO start, the engine may turn off again if the vehi…
The screws retaining the right fixed baring stud, fixing the rear wheel swinging arm may come loose from the frame.
On affected vehicles the screw/bolt in the range group catch bolts may come loose.
In specific vehicles the windscreen wiper motor venting device may be non-compliant. This may allow water to enter the wiper motor, creating internal corrosion and locking up the m…
In specific vehicles the windscreen wiper motor venting device may be non-compliant. This may allow water to enter the wiper motor, creating internal corrosion and locking up the m…
The air conditioning drainage hose, that is used to transfer condensation water generated by the air conditioning unit out of the vehicle, may not have been properly attached.
Moisture may penetrate the electric power steering control unit. This may interfere with signal transmission in the control unit and cause the steering power assistance to fail.
An incorrect seat wiring harness layout which can cause the seat wiring harness to rub against metal points on the seat/seat frame assembly.
The wires serving the hazard warning lamps may become damaged during normal steering action.
The fixed fork tube can suffer preliminary damage when unusual incidents with momentary high stress occur.
If the vehicle is in a frontal collision severe enough to deploy the front airbags, the airbags may deploy with too much force, due to the possibility of over set parameters.
The structural longevity of the Draw-Bar is uncertain on some caravan models constructed with an aluminium chassis due to the absence of strengthening gussets.
The Active Brake Assist (ABA) and Adaptive Cruise Control (ACC+) systems may become unavailable on specific vehicles due to an internal defect of the radar sensor.Before the failur…