Every safety recall published by the Australian government, searchable and filterable.
Due to an improper manufacturing process, the electrical power steering wiring harness may become trapped between the subframe and the subframe closing plate on right hand drive ve…
When strong gripping force is applied to the front brake lever, it may break.
In some instances, there is a risk that one or several fixing nuts may be missing from the individual rear passenger seat.
The seat belt may jam in the seat belt guide loop, causing the seat belt to loosen and not retract upon movement.
In some instances, the front driver air bag may not inflate to its fullest capacity fast enough when required.
The Totally Integrated Power Module (TIPM) may be configured incorrectly, preventing the headlamp leveling system from operating properly.
The brake pedal linkage clip may have been manufactured incorrectly. A defective or missing brake pedal linkage clip could cause the brake booster input rod to detach from the bra…
On Jeep Cherokee vehicles, the tyre placard in the vehicle listed an incorrect load and speed rating.On Dodge Nitro vehicles, the tyre placard in the vehicle listed an incorrect sp…
The front track bar mounting bolt may not have been tightened to specification. A loose mounting bolt may cause a rattle or banging noise under certain driving conditions.
The groove on the main shaft was incorrectly manufactured and is oversized, possibly resulting in the circlip loosening and causing gear damage.
The windshield and/or quarter glass may have been installed using an incorrect urethane adhesive.
The length of the rear wheel hub mounting bolts may prevent use of the park brake.
The windshield wipers may become inoperative.
The 12 volt auxiliary battery may stop charging due to improper soldering on the circuit board in the vehicles DC/DC converter.
The 12 volt auxiliary battery may stop charging due to improper soldering on the circuit board in the vehicles DC/DC converter.
During manufacture, wheel studs may not have been fully seated. A small gap may exist between the wheel studs and the hub assembly.Continued use of the vehicle may cause:the wheel…
Due to the improper materials used in the production of the brake light switch, the switch may corrode if exposed to water.
Some vehicles may be affected due to an incorrect software file, which may allow the driver to deactivate the passenger side airbag.
Caliper mounting bolts may not provide adequate clamping force between the brake caliper and brake anchor plate.
The spare part ignition switch may have imperfections in its ball springs. In the long term these imperfections may result in the failure of the ignition switch, which may cause th…
The left hand rear door window glass may have been inadequately tempered, due to an improper cooling process during manufacture.
The shock absorber may fail and cause potential separation of suspension components.
The X Class operator's manual contains an incorrect maximum roof loading. Roof loading may be from roof-top tents etc. The loading in the operator's manual is for the vehicle when…
The centre console switchpack may suffer a loss of illumination and operation of certain functions in the centre console, due to a software fault.
Due to a software defect, the automatic high beam headlights may not operate as intended.