Every safety recall published by the Australian government, searchable and filterable.
Material fatigue and subsequent cracking may occur on the spring support plates of the front struts. This problem mainly occurs at high mileage and after a long period of service.
A 50mm water tank support bracket(s) may be missing.
At certain high speed driving condition, the left hand front driveshaft may detach from the transmission causing a loss of driving force.
Poor sealing of the steering pitman arm dust boot may allow water ingress that can result in corrosion on the ball stud at the seal contact area. If this occurs, the strength of t…
A potential concern with the handbrake lever in vehicles produced btween March 29 2005 to May 18 2005. This concern, if not rectified, may cause the handbrake to be applied or una…
There is a possibility of the rear passenger doors becoming unlatched due to an incorrectly staked lever pivot in the external door handle assembly not returning the door latch to…
Clearance between the LHF brake pipe and the power steering hose fixing clip may be insufficient and vibration transmitted during normal vehicle operation may cause abrasion of the…
A potential concern with the wheel bearing cap. This concern, if not rectified, may allow water ingress to the wheel bearings
There is a possibility for the front lower control arms to develop cracks around the ball joint socket due to casting defects in the control arm.The potential exists for the ball j…
There is a possibility for excessive thermal heat to build up around the exhaust system.The potential exists for the excessive heat to cause electrical component failures, and in a…
The compliance plate currently fitted to vehicles affected by this campaign show an incorrect 'Gross Vehicle Mass' (GVM) value.
The park brake operating lever can jam if inadvertently actuated when already placed under upward tension. In this case the park brake lever could be incorrectly interpreted by th…
The possibility that during the original assembly the front hubs may have been incorrectly packed with grease. This has the potential to cause front hub bearing damage.
Each kit includes either 1,2 or 3 transverse beam assemblies & each transverse beam includes 2 cast ends which do not meet the required specification. The defective cast ends are…
The fuel filler pipes fitted to some models of RA Rodeo are designed and manufactured from a non-electrically conductive material. During filling of the petrol tank, an electrosta…
The rubber component of the rear engine mounts may crack during normal operation. Both front and rear engine mounts will be replaced. 47 vehicles will also require replacement of…
The rubber component of the rear engine mounts may crack during normal operation. Both front and rear engine mounts will be replaced. 47 vehicles will also require replacement of…
Owing to a possible combination of causes of the spot welding condition, the spot welds between the hood lock support and the hood inner panel may separate. If the vehicle is drive…
There is a possibility of the ABS sensor cable sagging into a loop in the vicinity of the front left brake caliper when disassembly work is carried out (tyre change, for example).…
A condition may occur where the front brake hose can slide out from the retaining bracket on the front strut.
Potential exists for a park brake bracket within the rear brake assembly to crack, particularly where the parking brake is used frequently or with force. Should the component crac…
The No 1 rear suspension arm may have been incorrectly welded. In instances where the weld is not to specification the arm may break at the bush housing weld area and in the worst…
There is a possibility that the front suspension lower ball joint may have been scratched. If the vehicle is operated for an extensive period in this condition, excessive wear of…
There is a possibility that the automatic transmission gear selection shift lever could come loose and fall out. This may result in the driver moving the shift lever into an unwan…
The MIL (Malfunction Indicator Lamp) will fail to illuminate when an automatic transmission OBD related malfunction occurs. However, the D indicator will flash if Automatic Transm…