Every safety recall published by the Australian government, searchable and filterable.
In vehicles where this condition exists, it is possible for the module to experience from minor distortion to considerable melting of the plastic around the HXFS fluid chamber. In…
There may be some Focus TDCi vehicles equipped with the DW10 (Diesel) engine that may not have had an exhaust heat shield fitted.
On certain Lexus LS460 and LS600hL vehicles the Steering Control ECU programming for the Variable Gear Ratio Steering (VGRS) system can result in the steering wheel becoming off-ce…
A concern has been detected relating to the installation of heavy 'Steel bull bars' and accessory devices such as winches being fitted to the front of these European models. In hig…
The affected carpet mat in the driver's footwell may interfere with the accelorator pedal.
In rare cases, stress generated by the back and forth movement of gasoline inside the fuel tank during lateral and longitudinal accelerations, accompanied by vertical vibration cou…
In some instances the carburetor return spring has failed.
There is a possibility of the wiring harness coming into contact with the cooling fan blade causing damage to the harness.
Certain MY10 Liberty and Outback vehicles fitted with the CVT may experience an oil leak from a faulty oil cooler hose.
On certain BT-50 vehicles, the bonnet striker may receive more lateral input than expected when driven in severe conditions like a rough road and/or if the bonnet fitting condition…
A production condition during the wheel and tyre assembly process may have resulted in a tear in the tyre sidewall.
The strength of the wire clip retaining the oil pressure pipe to the clutch master cylinder may be insufficient allowing the pipe to become disconnected during clutch operation.
Some Jayco Pop Tops may have been manufactured with the incorrect tyres based on the overall weight of the van.
On Alfa Romeo 147 vehilces with Pirelli tyres (215/40 ZR18 89W PZero (MO), a crakcing of the tyre sidewall could occur, due to a non-compliance
Possible damage to the fuel system pipes caused by incorrect assembly of the screw clamp fastening the thermostat water pipe coupling.
Due to a misarranged wiring harness the stop lamp circuit and shift solenoid circuit may have their couplers interchanged when connected to the stop lamp switch. This may result in…
May have an incorrect or missing Stationary Noise Label.
During the fitting of the Front Underrun Protection Device (FUPD) it has been identified that bolts of insufficient length have been used and the incorrect torque specification app…
During the initial charging of the CNG fuel tank, by lowering the temperature of the gas, cracks developed in the soluble alloy of the safety valve. Subsequent charging of the fuel…
Certain 10MY Tribeca vehicles may experience interference between the front door latch cables and the front door window regulators when the windows are operated possibly resulting…
There is a possibility for the seat backrest to fold inadvertently when adjusting the seat position and seat position sensor failure.
The fleece filter insert in the oil separator of the engine breather system could become blocked with residues over time and cause the crankcase to become pressurised. Should this…
Distance between the diesel return pipe and engine acoustic cover could be insufficient. Consequences: Pipe to wear.
Affected vehicles may have a park brake lever with a manufacturing defect. If a park brake lever with this defect was to be knocked whilst engaged, it may cause the park brake syst…
Investigations have identified that the steering gear high pressure lines joint connecting to the steering gear may not be properly assembled. Should this condition occur the custo…