Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue, there is a possibility of insufficient sealing between the high voltage battery casing and battery cover. This could lead to moisture entering the hig…
The front windshield wipers may fail. In the event of rain this may lead to poor visibility for the driver.
Due to a manufacturing defect, the mounting position of the rear tail lamps and the rear turning indicators may not meet specification. As a result, during dark conditions, the tra…
Due to a manufacturing defect, the bonnet outer panel and inner frame may not have been bonded correctly. As a result, the bonnet outer panel could detach due to vibrations whilst…
Due to a configuration setting issue, the vehicle’s tilt sensor that detects any change to the vehicle angle relative to the ground may not activate as intended.
Due to a manufacturing issue, the seat belt pre-tensioner inflator cap may fracture when deployed in the event of an accident.
The side stand mounting bracket spring retaining pin may break. This could cause the side stand to open whilst riding and the stand sensor to switch off the engine, resulting in a…
During the manufacturing process, the Restraint Control Module (RCM) was loaded with an incorrect configuration. As a result, if an incorrect replacement part is installed in the s…
Due to a manufacturing issue, the rear shock absorber adjuster mounting bolt may break. As a result, the shock absorber adjuster could loosen and contact the rear tyre causing a lo…
Due to a manufacturing defect, the 48 Volt battery is susceptible to water ingress if exposed to moisture for extended periods. Water ingress can cause the battery to overheat whic…
Due to a potential design concern with the rear tail lights control circuit, the turn and hazard indicators lamps may not illuminate as intended.
Due to manufacturing defect, there is a possibility that the steer axle tie rod castle nut cotter pin is missing, allowing the steering arm to detach. This could lead to a loss of…
Due to an installation defect, the internal fuse box wiring harness may become loose. If this occurs, the instrument cluster may fail to illuminate, internal, external lamps may sw…
Seats installed in seat-belted buses may not meet the requirement for minimum seat spacings and fixings for route service buses. This may result in the seat not maintaining the min…
Due to a manufacturing defect, the main fuse box wiring harness may come in contact with the metal engine mounting bracket. As a result, the wiring harness could become damaged ove…
Due to incorrect installation, the power distribution box wiring harness may contact and chafe against the air conditioner control unit. This may lead to an electrical short circui…
The clock spring electrical connection between the steering wheel airbag, horn and electrical systems may be prone to dust entry and possible failure. If this occurs, it could resu…
Due to a manufacturing defect, the hose leading to the manifold air pressure sensor may become obstructed. This may lead to unstable idle and possible engine stall resulting in a l…
Due to a manufacturing defect, the mounting bolts and nuts that are used to secure the hitch to the towbar of the brush chipper may not meet specifications. If the hitch mounting b…
Due to a software issue, the turn indicators may not illuminate as intended.
The welding connection joining the airbag guide channel and the dash panel of the front passenger’s side, may not meet manufacturing specifications. As a result, the front passenge…
Due to a software issue, under certain circumstances if the battery level drops below a critical threshold, the transmission may shift into Park when the vehicle is travelling at s…
Due to a design defect, the wiring harness within the fuel tank may overheat and melt the fuel inlet flange material. If this occurs fuel may leak, and if exposed to an external ig…
The engine compartment main fuse box connection bolts may not meet specifications and could loosen. If this occurs, it may lead to a sudden loss of motive power and/or a vehicle fi…
The driver's airbag inflator may rupture in the event of airbag deployment.