Every safety recall published by the Australian government, searchable and filterable.
The seat rail locking mechanism fitted to the front seats may fail to lock and cause the seat to move forwards or backwards unexpectedly.
There is a possibility that the park brake may self-release as a consequence of an impact with the park brake lever.
It is possible that individual components of the ABS Control Unit may overheat due to an electrical fault within this unit.
In extreme circumstances the anti-roll bar clamp could break. A noise from the front suspension could be apparent under this condition.
There is a risk that an electrical fault in the ABS control unit can possibly cause overheating of certain components which in some cases could lead to fire.
Have been fitted with incorrectly manufactured crankshaft position sensors which could lead to engine stalling.
Not provided with the Australian Design Rule (ADR) 37/01 mandated 'Unleaded Fuel Use Only' label during production.
If the seatbelt pre tensioner of the front occupant seats deploys in an accident, there is a possibility that due to a manufacturing discrepancy, the pre tensioner manifold cap cou…
The brass flare nuts fitted to the LPG supply pipes may crack resulting in LPG leakage. These flare nuts are fitted at each end of the three separate sections of the LPG supply pi…
Could have been built with cracked front mounts on the rear shock absorber. This defect could potentially lead to sudden change in suspension height without prior warning, thus po…
Some of the affected ball socket assemblies may wear out prematurely, leading to a potential separation, which could result in partial, or total loss of steering control.
It is possible that the brake booster vacuum hose may swell if it comes in contact with oil and become dislodged from the engine. Should this occur, a loss of power brake assistan…
The fault relates to the left-hand steering swivel member where it mounts to the ball joint. Two batches of steering castings may have been contaminated by defective material caus…
It is possible for seat belt pre-tensioner units to activate unnecessarily when the ignition is switched on.
Due to insufficient length of the cruise control cable there is a likelihood that the vehicle accelerator may cause the vehicle to inadvertently increase speed.
The lower portion of the Driver Side Airbag Cover (horn pad) may become detached from the airbag module during deployment. In the worst case, there is a possibility that the detac…
The front suspension lower ball joint may not be retained in the knuckle assembly under all circumstances. Excessive kerbing or grounding of the vehicle may cause the ball joint t…
The engine compartment wiring loom may chafe on the thermostat housing bolt. This chafe condition, if not attended to, may result in damage to the wiring loom.
The accelerator pedal base plate may crack around the hinge pin area.
Faulty throttle body cable lever.
Possibility of incomplete welding on the steering handlebar.
There may be a possibility that the clutch cable fitted to some vehicles within model range may become frayed.
Due to the brittle condition of the metal used, the towbar tongue can snap.
There is a possibility that the crankshaft pulley bolt may come loose. In the worst case this may result in the pulley spinning on the crankshaft rendering the power steering pump…
Towbar tongues manufactured by Frontline could break whilst towing due to a brittle condition of the material.