Every safety recall published by the Australian government, searchable and filterable.
Due to overheating, the headlight may function incorrectly.
Due to an incorrect procedure during manufacture of the Rocker Arm Shaft Sealing Bolt, it may come loose causing oil to leak from the engine.
Overseas models fitted with the same cabin are experiencing “de-lamination” of the sun visor supports which can lead to detachment of the visor.
The Throttle Pedal Arm may break.
A limited number of Triumph Tiger Explorer and Trophy model motorcycles require replacement of their Engine Control Module (ECM) due to electrical interference from the throttle po…
When the vehicle is driven, the wiring harness may come in contact with the bottom of the radiator and wear through the outer protective sleeve.
The Daytime Running Lamps (DRL) do not function correctly when the turn signal indicator is used.
Due to insufficient tightening torque of the engine’s air compressor cylinder head bolts on affected vehicles, the cylinder head gaskets may sustain damage.
Air may remain in the brake hydraulic unit due to improper brake line air venting procedures during vehicle manufacture.
The motorcycles may require the addition of a centre stand bracket.
The rims may crack or become damaged.
A number of clamp sleeves for the draglink of the first axle have been found to break during fitting. This failure has been caused by excessive torquing of the nuts.
BMW Motorrad has noticed that in some cases an incorrect fault entry has been programmed into the fault memory of the Digital Motor Electronics System (DME).
There is a possibility of improper welding on Front Suspension Lower Control Arms (LCA) produced prior to Friday, 11 May 2012 which may result in the weld failing.
A fuse that protects some of the exterior vehicle lights may blow due to thermal overload.
Yamaha has determined that the resistance in the wire harness between the APS,TPS and ECU may increase due to a manufacturing defect in the wire harness at the time of production.…
Due to insufficient weld strength the clutch master cylinder may break whilst it is operating. In this case the fluid will leak and the clutch release function will cease to operat…
The front brake cable may break. If this occurs the front brake becomes inoperable, in addition, the parking brake no longer functions.
The daytime running lamps may illuminate at low intensity output, instead of the desired high intensity output, during certain driving conditions.
Over time the vacuum pump may fail completely due to a lack of lubrication. As a result, the power brake booster unit is not supplied with sufficient vacuum force, which reduces th…
These trucks could have an issue with the engine insulation sagging and contacting the high temperature side of the EGR cooler.
The cab tilt cylinder lock nut may not have been correctly tensioned during manufacture.
The tyre placard label on affected vehicles were printed without tyre speed and load rating information.
Nissan has identified that due to lateral load on the accelerator pedal, the contact pressure of the sensor brush to a terminal on the circuit board of the subject sensor may deter…
After operating the power seats reclining lever, the lever may stick in the operating position, allowing continuous current flow to the reclining motor.