Every safety recall published by the Australian government, searchable and filterable.
The electric power steering assistance may be interrupted due to improper harness layout and terminal wear. Manual steering control is maintained.
The lower mount for the right rear seat belt may not have been fitted according to specification.
The detent lever of the child lock can break because it was damaged during the production process. As a result of this an active child lock can unnoticeably be switched off. This m…
The brake fluid reservoir may not have been properly secured during production.
The front fender bracket may fail causing the front fender to become loose.
Due to a software concern within the engine control unit the engine may stall when braking at low speed.
There is a defect in the electronic power steering gearbox in certain 11MY Colt vehicles. Due to improper crimping of the terminal connection between the steering force torque sens…
The detent lever of the child lock can break because it was damaged during the production process. As a result of this an active child lock can unnoticeably be switched off. This m…
Due to a running vehicle wiring harness design change at Mitsubishi, the electric trailer brake accessory harness that Mitsubishi had been selling is not suitable for 16MY Outlande…
Curtain shield air bag inflators located in the driver and passenger side roof rails are composed of two chambers welded together. Some inflators could have a small crack in the we…
The brake warning lamp may illuminate due to improper software judgement that the vacuum pump relay has seized. On selected vehicles the location of the brake vacuum pump exhaust m…
Curtain shield air bag inflators located in the driver and passenger side roof rails are composed of two chambers welded together. Some inflators could have a small crack in the we…
Due to a potential fault in the clutch assembly, one of the clutch components may break, increasing the risk of rear wheel lock up during use of the bike.
It is possible that the rear wheel rim might have been installed in the wrong way, with the 4 rear wheel shaft driving pins inserted in the slots rather than in the 4 relevant hole…
The door locks could have a manufacture flaw potentially causing the internal mechanism of one or more locks to jam, which could prevent one or more vehicle door(s) from closing, o…
The door locks could have a manufacture flaw potentially causing the internal mechanism of one or more locks to jam, which could prevent one or more vehicle door(s) from closing, o…
A bolt retaining the accessory drive belt idler pulley may fail, leading to a loss of accessory drive. As a result, the driver may experience battery charge warning lamp illuminati…
Incorrectly sized nuts may have been fitted to the tie rods on the rear axle. If these nuts come loose it may alter the steering characteristics of the vehicle.
Due to potentially incorrect installation of some of the stop lamp switches at the point of assembly, the stop lamp switch on some of the affected vehicles may malfunction over tim…
The inner diameter of the cylinder that wraps the piston on the parking brake may be wider and therefore not sealing inside the caliper.
The inner diameter of the cylinder that wraps the piston on the parking brake may be wider and therefore not sealing inside the caliper.
The high pressure brake booster hose may come in contact with the sub frame near the left hand engine mount.
Risk of rear bench seat backrest mounting bolts breaking.
The weld nuts for the child restraint anchor fitting may be missing at both the driver's and passenger side rear restraint point. There should be 3 usable points. This violates Aus…
A condition has been identified whereby, over an extended period of time, fretting corrosion may develop in a wiring connector at the Engine Control Module (ECM).