Every safety recall published by the Australian government, searchable and filterable.
A condition can occur where the Diesel fuel Injector internal sealing may deteriorate and potentially allow fuel to leak into the engine crank case and contaminate the engine oil.
During heavy winching operations, there is a possibility that the welds on the bullbar adaptor mounting brackets which attach the bullbar to the vehicle may fracture and in the wor…
One or more of the special fasteners securing the hub to the steering wheel may be too short to provide the required engagement on the pin, which in turn could cause the steering w…
Poor contact between ignition switch contacts may lead to arcing, causing burning of the contacts and increased electrical resistance. Heat generated due to the increased resistanc…
In rare cases the rear cross-member and the rear small side members do not comply with manufacturer's specifications.
There is a concerned relating to the brake pads fitted on a limited range of axles equipped with maxi brakes. This may cause overheating due to the dragging brake pads.
There is a potenial safety concern that relates to the knuckle arm fixing bolts. The longer of the two bolts has been incorrectly manufactured and has not been heat treated inline…
The original engine managment software can, in rare cases, cause the engine to stall in cold temperatures.
In rare cases, the Exhaust Gas Recirculation Valve (EGR) may cause hard starting/stalling and cause the engine diagnostics warning light to illuminate on the instrument panel.
In rare cases, the Exhaust Gas Recirculation Valve (EGR) may cause hard starting/stalling and cause the engine diagnostics warning light to illuminate on the instrument panel.
There is a possibility that the steering intermediate shaft may become loose or develop a crack. In the worst case, if the vehicle continues to be operated under these conditions,…
There is an issue that may result in excessive wear of the rear wheel bearings that will lead to noise occuring from the rear axle. If this is not rectified, the bearings could ult…
There is a posibility the door foot pads may break.
There is a possibility the front axle wheel hubs fitted to these trucks may crack if subjected to overload overload conditions, or from excessive tensioning of the wheel nuts, duri…
Connection between shaft and universal joint on steering propshaft may work loose.
These models are susceptible to interference from high voltage signals either from an external source or due to engine ignition system malfunction or as a result of unauthorised mo…
The stop of the brake pedal collapse system may be missing which in extreme circumstances could diminish braking efficiency and affect safety.
The rubber grommets for the alternator protective casing are too soft. As a result, the grommets work loose and the alternator cables chafe against the metal edges and break.
Due to insufficient strength of the rear axle shaft flange, a crack may develop at the neck of the flange if the vehicle is operated in certain driving conditions, such as repeated…
The outer tie rod end joints, on the steering gear, may fracture.
The Fuel Filler Tube may rust at the tube mounting bracket as a result of the plating and painting (powder coating) which may have been insufficiently applied. If a pinhole is form…
1. Water ingress past the 'O' ring seal possibly causing corrosion on electrical contacts and possible failure of the fuel pump.2. There is a possibility that if work is undertaken…
1. Water ingress past the 'O' ring seal possibly causing corrosion on electrical contacts and possible failure of the fuel pump.2. There is a possibility that if work is undertaken…
Intermittent hard starting/stalling problems and the illumination of the engine check light.
It has been determined that the fuel line connecting to the engine is sensitive to extreme temperatures, that may occur in the area where the turbo/exhaust manifold is located, pot…