Every safety recall published by the Australian government, searchable and filterable.
The gas pipe for the hot water service may have been damaged during manufacture of the motor home.
Selected motor homes may have been manufactured with a screw that has been screwed through the floor, possibly piercing the wiring loom.
The brake tube(s) on your vehicle may have been built with an improperly formed flare that could cause brake fluid leakage.
Air bag control unit software non-compliance in cases of side impact.
The in-tank electric fuel pump may not be correctly activated following a vehicle start-up cycle.
There have been instances where the M20 bolts for the spring brackets for the driven axle and tag axle, have not been tightened to the correct torque during production.
The horn may fail to operate due to the routing of the electrical harness inside the steering wheel pad.
The chain guide bracket is not welded properly on the swingarm. This could result in weld cracking which may cause the drive chain to derail from the rear sprocket.
The affected vehicles are not compliant with the latest ADR regulations. The vehicles are fitted with a lap belt on the passenger side instead of a lap sash belt as per ADR regulat…
On certain Land Cruiser Saraha 100 and Lexus LX470 vehicles, the construction of the steering shaft is such that the snap ring on the shaft may disengage when the vehicle experienc…
A number of vehicles may have been delivered with deficient quality in the welding that holds the foot plate to the brake and clutch pedal.
The circuit resistance of the Accelorator Position Sensor (APS) and Throttle Position Sensor (TPS) in the wire harness may increase due to a defective ground connection between APS…
It is possible that the top of the motorcycle rider's shoe cold hit the right lower fairing while braking. This obstruction may result in the rider not being able to apply the brak…
The front suspension may cause the brake hose to come in contact with the front brake rotor resulting in damage to the brake hose.
The spring band clamp mounted on the radiator hose connection to the water inlet pipe spigot may not sufficiently secure the hose, potentially leading to the hose coming loose duri…
Distance between the diesel return pipe and engine acoustic cover could be insufficient. A holding fastener must be placed on the fuel return pipe to prevent any contact with the e…
The integral clip-tabs on the decorative hood louvre may break causing the louvre to lose its retention mechanism. As the clip-tabs break, the louvre may rattle against the hood.
A limited number of 6MT gearboxes were produced without a necessary lubrication supply passage. The lubrication passage is designed to ensure longevity of the transmission, and no…
When bringing a vehicle equipped with the SE5 semi-automatic transmission to a full stop, the clutch may remain engaged stalling the engine. Once the engine is stalled, it could be…
Due to the possibility of interference between the power steering box worm shaft oil holes and oil seal on affected trucks, the oil seal may fail.
The Owner's Manual does not contain any information regarding sunroof operation.
A manufacturing defect in the fuel pressure line may result in a fuel smell and/or fuel seepage.
A condition can occur under specific operating conditions where the tailgate may unlatch when impacted rearwards with sufficient energy by unsecured objects placed in the rear carg…
The rear reflector may not meet the required manufacturing standard.
The valve spring material may not have sufficient strength.